Bose 300PM 서비스 매뉴얼 - 페이지 7
{카테고리_이름} Bose 300PM에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 300PM 16 페이지.
Bose 300PM에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지)
페이지 인쇄
Power Amplifier
-
+
+
-
Frequency
Generator
Figure 1. Model 300PM Loudspeaker test
setup diagram
Note: Refer to Figure 2. Model 300PM
driver wiring diagram for the following
procedure.
1. Phase Test
1.1 Remove the speaker grille using
Disassembly/Assembly procedure 1.
1.2 Observing polarity, apply a +6Vdc level
to the input terminals on the rear of the
loudspeaker. The drivers should both
move outward.
1.3 Replace the grille using procedure 2.
Note: Refer to Figure 1. Model 300PM
Loudspeaker test setup diagram, for the
following tests.
2. Rub and tick test
2.1 Remove the grille using procedure 1.
2.2 Apply a 6Vrms, 10Hz signal to the
input terminals on the rear of the speaker
cabinet.
2.3 Listen carefully for any buzzes, rattles,
or other extraneous noises from the drivers
or trim parts.
Note: There is a normal suspension noise.
To distinguish between a rub or a tick and
suspension noise, displace the driver cone
slightly with a finger. If the noise stays the
same, it is suspension noise.
TEST PROCEDURES
-
+
+
-
DMM
+
Loudspeaker
-
2.4 Replace the grille using procedure 2.
3. Air Leak Test
3.1 Remove the grille using procedure 1.
3.2 Apply a 6Vrms, 60Hz signal to the
input terminals on the rear of the speaker
cabinet. Leave the speaker port open.
3.3 Test duration should be 5 seconds
minimum.
3.4 Listen carefully for air leaks along all
glue joints, at the binding post connector,
and at both transducer mounting locations.
Air leaks will be heard as a hissing or
sputtering sound. All repairs must be
hidden.
3.5 Replace the grille using procedure 2.
4. Power Sweep Test
4.1 Apply a 6Vrms, 10Hz signal to the
input terminals on the rear of the speaker
cabinet. Leave the speaker port open.
4.2 Sweep the input frequency from 10Hz
to 3kHz.
4.3 Reduce the input voltage level to
4Vrms and sweep the oscillator from 3kHz
to 5kHz.
Note: The whooshing noise from the port
at approximately 60Hz is acceptable.
4.4 Replace any transducer that has a
buzzing noise. There shall not be any
buzzes or rattles from the internal
connecting wires or components.
Redress any buzzing wires.
7