Bose 701 Series II Speaker 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Bose 701 Series II Speaker에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 701 Series II Speaker 12 페이지. Direct/reflecting speakers

AM257817_00_V.pdf

Setting your non-digital receiver

After making the connections, you may try additional surround sound modes that your

receiver may have. These modes may have different names depending on the manufacturer,

e.g. ACTION, MOVIE, THEATER. Select the settings for music, movies, or both that sound

best in your listening environment. See your receiver/ampliﬁer owner's guide for additional

information on selecting settings.

CAUTION: 701

speakers incorporate an automatic protection circuit, which guards against

most kinds of damage from electrical stress or overload. This circuit activates at high volume

levels to reduce output, causing a slight decrease in volume. You may also notice light com-

ing from inside the speaker cabinet. This is normal operation and indicates that power input

may be exceeding safe levels. Sustained listening at these levels is not recommended.

Your speakers are fully compatible with the output from most receivers containing digital

technology. The table below suggests the recommended settings. Because they are full-

range speakers, select LARGE on the digital screen menu. Turn the subwoofer and the LFE

(low frequency effects) on. The preferred crossover setting should be 150 Hz.

Speaker

Left and right front

Center

Surround

Subwoofer

LFE

Your left main speaker has two control knobs – one for bass control and one for LFE control.

Follow the instructions below for using these controls.

The bass control, located on the outside of the left main speaker, can help you customize the

speakers to your listening room. Turning the control to the right will add bass to the sound in

rooms that might be characterized as too shrill. Turning the control to the left will "brighten"

the sound of the listening room. As with LFE control, you may ﬁnd the factory setting to be

completely appropriate for your listening room.

The LFE control, located on the outside of your left main speaker, increases or decreases the

relative level of low frequency effects on movie sound tracks. Use it to regulate the presence

of these underlying deep bass sounds. You may ﬁnd it unnecessary to adjust this control. The

factory, or detent, setting is appropriate for a majority of listening situations.

October 25, 2001

Receiver setting

LARGE

SMALL

Setting Up