Bose 802 C II 소유자 매뉴얼 - 페이지 3
{카테고리_이름} Bose 802 C II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 802 C II 22 페이지. System controllers
Bose 802 C II에 대해서도 마찬가지입니다: 서비스 매뉴얼 (20 페이지), 서비스 매뉴얼 (23 페이지)
페이지 인쇄
1.0 Before you
Begin
Thank you for purchasing the Bose
II systems controller.
In this owner's guide, sections two and three list
safety, general descriptions, and main features for
both controllers. Section four shows examples of
complete systems in some typical applications. The
remaining section describes basic controller hook-
up. It also gives general electrical and operating
instructions.
See Appendix A for how to install the Acoustic Wave
Cannon
System II speaker option card (OC-). It is
TM
important that the OC- be installed by authorized
Bose personnel. Appendix B gives the electrical and
mechanical specifications of the 40C and 80C II
systems controllers. Appendix C gives warranty and
service information.
40
C or 80
C
®
TM
®
®
2.0 safety
Information
Please read this safety information before you
install, connect, or operate the Bose 40C or 80C II
systems controllers.
2.1 Read the instructions. Read and then keep all
safety and operating instructions for future reference.
2.2 Follow cautions. For your safety, follow all
cautions and warnings in the Owner's Guide and on
the controller.
2.3 Avoid moisture. Never expose the controller
to water or excessive humidity. Do not install near
swimming pools, spas, or in other very humid
environments.
2.4 Avoid heat. Do not use the controller near
excessive heat sources. These include radiators,
heat registers, flood lamps, spotlights, stoves, and
other appliances.
2.5 Protect cables. Always route cables to keep
them from being pinched or cut by heavy or sharp
objects.
2.6 Connect the ground wire. Make sure you
properly connect the ground pin (if included) on
the power cord of the controller. It connects to the
ground of the power mains.
2.7 Vent the system. Properly vent the controller
if you mount it in a rack with other electronic
equipment. Vent the rear of the rack to prevent
excessive heat build-up.
2.8 If damage occurs. Refer servicing to qualified
service personnel under the following conditions:
A. If liquid spills into the unit.
B. If the unit is exposed to rain or water.
C. If the unit does not operate normally, even
though you have followed the instructions in this
manual.
D. If the unit exhibits a distinct change in
performance.
2.9 Check for safety. Following service or repairs,
ask the service technician to perform safety checks.
This includes proper connection of the ground wire
from the controller to the power mains.
3