Bose 901 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Bose 901에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 901 41 페이지. Vi direct/reflecting speaker system
Bose 901에 대해서도 마찬가지입니다: 소유자 매뉴얼 (23 페이지), 조립 및 장착 지침 (1 페이지), 소유자 매뉴얼 (12 페이지), 설치 및 운영 매뉴얼 (15 페이지), 소유자 매뉴얼 (20 페이지)

Setting Up

Testing the speakers and equalizer

Choose the test method appropriate to your system:

To test the TAPE MONITOR connection

1. Turn off or disconnect any non-901 speakers or headphones that may be connected.

2. On the 901

active equalizer, press the MONITOR button IN to TAPE, and the BASS

button OUT to position 1.

3. Set the MID-BASS and MID-TREBLE sliders to center positions.

4. Press your receiver or amplifier TAPE or TAPE MONITOR button to the OUT or NORMAL

position so it is not selected.

5. Play music through your system. You should hear both speakers. Do not worry about the

sound quality at this point. The equalizer is not yet engaged. If there is no sound from one

or both speakers, check the receiver and speaker connections.

6. Move the receiver BALANCE control to the extreme left and then to the extreme right.

This tests the left and right channel orientation. If the channels are reversed, check the

connections.

To test the equalizer

You have now tested your speakers and their wiring. The following steps test the equalizer

and its wiring:

1. With the speakers playing, press the receiver TAPE or TAPE MONITOR button IN, select-

ing the PLAY or MONITOR position. All sound should stop. If it does not, check your

equalizer wiring. Be sure the 901 active equalizer MONITOR button is set to position 2

(TAPE).

2. Press the 901 active equalizer MONITOR button to SOURCE, position 1. The sound

should return with full, natural sound characteristics. The system is now ready for use.

If the sound does not return, and the equalizer power indicator is lit, the equalizer is

probably connected incorrectly. Review equalizer connections.

To test the PRE AMP OUT/MAIN AMP IN connection

If you have connected the 901 active equalizer to the PRE AMP OUT/MAIN AMP IN connec-

tion, follow these instructions to test the speakers, equalizer, and wiring before connecting

any other equipment to your system.

1. Turn off or disconnect any non-901 speakers or headphones that may be connected.

If your system has a speaker selector switch, set it so that only the 901 speakers are

connected to your power amplifier.

2. On the 901 active equalizer, press the MONITOR button OUT to SOURCE, and the BASS

button OUT to position 1.

3. Set the MID-BASS and MID-TREBLE sliders to center positions.

4. Play music through your system. You should hear both speakers. If there is no sound from

one or both speakers, check to see that the power indicator on the equalizer is lit, then

check the receiver and speaker connections.