Bose 901 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Bose 901에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 901 23 페이지. Vi direct/reflecting speaker system
Bose 901에 대해서도 마찬가지입니다: 소유자 매뉴얼 (41 페이지), 조립 및 장착 지침 (1 페이지), 소유자 매뉴얼 (12 페이지), 설치 및 운영 매뉴얼 (15 페이지), 소유자 매뉴얼 (20 페이지)

Setting Up

Figure 5

Connecting to the tape monitor

connection

Figure 6

Removing horseshoe pins

3. Connect one end of a cable to the AMPLIFIER INPUT jacks on the 901

a. Insert the first connector firmly into the INPUT jack marked R.

b. Insert the second connector into the INPUT jack marked L.

4. Connect the other end of the cable to the OUT or RECORD jacks on your receiver. These

jacks may be marked TO INPUT, FROM INPUT, or REC.

a. Insert the first connector into the OUT or RECORD jack marked R.

b. Insert the second connector into the OUT or RECORD jack marked L.

5. Connect the second cable from the AMPLIFIER OUTPUT jacks on the 901 active equalizer

to the IN or TAPE jacks on your receiver. These jacks may be marked PLAY, TO OUTPUT,

FROM OUTPUT, or MONITOR.

6. Plug the power cord of the 901 active equalizer into one of the switched outlets on the

receiver so that it will be powered when the receiver is switched on.

Home theater use

(PRE AMP OUT/MAIN AMP IN)

Use these instructions:

• for stereo-only operation if your receiver does not have a TAPE MONITOR connection.

• if you are using a surround sound receiver that has a section on the back marked PRE

AMP OUT/MAIN AMP IN. The jacks may be labeled ADAPTER or SIGNAL PROCESSOR.

Note: If your receiver does not have this PRE AMP OUT/MAIN AMP IN section, the 901

speakers will not be usable in your home theater system.

1. The PRE AMP OUT/MAIN AMP IN jacks on your receiver are usually connected by small

bars called horseshoe pins. Remove these pins. See Figure 6.

Amplifier or Receiver

PRE

MAIN

AMP

OUT

November 21, 2001

active equalizer.

AM195438_03_V.pdf