Bose Acoustic Wave Series II 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Bose Acoustic Wave Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustic Wave Series II 20 페이지. 4x4 mic/line input/output card
Bose Acoustic Wave Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 설치 (3 페이지), 매뉴얼 (2 페이지), 매뉴얼 (46 페이지)
페이지 인쇄
Clock Functions
ON/OFF
ALARM
SET
ALARM
SET
ALARM MODE
VOLUME
ON/OFF
SLEEP/SNOOZE
ON/OFF
ALARM MODE
ALARM
SET
ALARM MODE
ALARM
SET
PRESET STATIONS
ON/OFF
14
Radio Control Operation
To use
While the alarm sounds, press ON/OFF once. The alarm
Auto Reset
stops and resets to go off at the same time tomorrow. If you
do not turn off the alarm, it continues to sound for 30
minutes. Then it stops and resets to go off at the same time
tomorrow.
To check
Press ALARM SET. The display shows the wake up time
Alarm 1
for Alarm 1.
To check
Simultaneously press both ALARM SET and ALARM MODE.
Alarm 2
The display shows the wake up time for Alarm 2.
For the radio (
To set the
volume of
For tone (
the alarm
Set the alarm to go off. When the alarm sounds, press either
VOLUME button to adjust the volume.
Press ON/OFF to silence the alarm. This automatically resets
the alarm to repeat tomorrow.
To snooze
When the alarm is in tone (
SLEEP/SNOOZE to pause the alarm for ten minutes.
When the alarm is in tone and radio (
SLEEP/SNOOZE to pause the tone and hear the radio. The
tone sounds again in ten minutes. Press again to silence the
radio. The alarm indicator flashes while paused.
To stop
Press ON/OFF once. The indicators remain lit. The alarm
the alarm
repeats tomorrow.
To disable
To turn off the alarm function, press ALARM MODE until
Alarm 1
the (
) and (
The alarm must be reset for next use.
To disable
Hold down ALARM SET and press ALARM MODE. Alarm 2
Alarm 2
flashes on the display. Release ALARM SET. Press ALARM
MODE until the (
To wake to
Simultaneously press ALARM SET and any PRESET button.
your favorite
The preset indicator and the station frequency flash on the
station
display.
Release the ALARM SET button. Alarm 1 plays this station
until you reset the alarm.
Alarm
Press ON/OFF to silence. Backup batteries run the alarm
operation
for approximately a week during power failure. To conserve
during a
power, only the tone sounds, even if radio is selected. Normal
power failure
operation resumes when power is restored. Batteries should
be replaced after an extended power failure.
January 4, 2002
), use the VOLUME buttons to set the volume.
), choose the alarm sound (see page 12).
) or radio (
) mode, press
) mode, press
) indicators do not appear on the display.
) and (
) indicators no longer appear.
AM189930_01_V.pdf