Bose Companion 3 Series II 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Bose Companion 3 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Companion 3 Series II 40 페이지. Multimedia speaker system
Bose Companion 3 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (22 페이지), 소유자 매뉴얼 (10 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (26 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 자세한 조립 지침 (2 페이지), 설치 매뉴얼 (20 페이지), 사양 (6 페이지), 브로셔 및 사양 (4 페이지), 소유자 매뉴얼 (19 페이지), 서비스 매뉴얼 (36 페이지), 서비스 매뉴얼 (16 페이지)

Operating the Companion

Figure 7

Control pod features

3 multimedia speaker system

Turning your speaker system on and off

1. Turn on your computer or sound source.

2. Turn the power switch on the back of the Acoustimass

Note: To conserve energy, your system can be put into standby mode. The mute or standby

mode is activated by touching the center portion of the control pod and indicated by the yellow

light.

Adjusting the sound

The acoustics of your listening room affect the sound quality of any speaker system.

Upholstered furniture, wall-to-wall carpets, or heavy drapes can muffle the treble (high

frequencies). Bare floors and walls and unupholstered furniture reflect the treble and may

cause it to sound too shrill.

Bass

After listening to your speaker system, you may wish to adjust the sound. Use the bass

compensation control on the Acoustimass module. Turn the control clockwise to increase, or

counterclockwise to decrease bass. You may also adjust the placement of the module to

affect bass; simply aim the port of the module away from the wall to decrease bass, or toward

the wall to increase bass.

Volume

Use the volume control on the control pod. Rotate the outer ring clockwise to increase, or

counterclockwise to decrease the volume (Figure 7).

To mute the system, gently tap the silver touch-sensitive panel on the control pod. Tap again

to unmute. The indicator light turns yellow when the system is muted, and green when it is

active.

Volume control

Headphone jack

Note: Using the volume controls in their maximum position may reduce the speaker system's

maximum volume, by causing the internal protection circuity to engage.

If you wish to control volume at the sound source instead of from the control pod, set the

volume control on the control pod near maximum volume; then make all other adjustments

using the volume control on your sound source. For instance, you may be able to control the

volume on your computer from its control panel.

Standby/Active indicator

Touch-sensitive mute/unmute switch

Operation

module to ON (I).

Sound source input