Bose F1 Model 812 Passive 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Bose F1 Model 812 Passive에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose F1 Model 812 Passive 24 페이지. Flexible array loudspeaker system
Bose F1 Model 812 Passive에 대해서도 마찬가지입니다: 설치 및 안전 매뉴얼 (20 페이지)

페이지 인쇄
Bose F1 Model 812 Passive 소유자 매뉴얼
Operation

Power On/Off Sequence

When turning the system on, turn on input sources and mixing consoles first and then turn on the F1 Model 812
Loudspeaker and the F1 Subwoofer. When turning the system off, turn off the F1 Model 812 and F1 Subwoofer first
followed by input sources and mixing consoles.

Setting EQ selector switches

Recommended settings for the EQ selector switches on the F1 Model 812 Loudspeaker and the F1 Subwoofer are
describe in the following table.
System Setup
F1 Model 812 Loudspeaker used without F1 Subwoofer
Signal input to F1 Subwoofer, F1 Subwoofer output to F1 Model 812 Loudspeaker
Signal input to F1 Model 812 Loudspeaker, F1 Model 812 output to F1 Subwoofer
*Provides more bass extension.

Connecting Sources

Before plugging in a sound source, turn the VOLUME control of the channel fully counter-clockwise.
The two independent inputs provide a combination of input connectors that can accomodate microphone and
line-level sources.
Note: Only dynamic or self-powered microphones can be used for INPUT 1.

Setting Up INPUT 1 with a Microphone

1. Turn the INPUT 1 VOLUME fully counter-clockwise.
2. Set the SIGNAL INPUT switch to MIC.
3. Plug the mic cable into the INPUT 1 connector.
4. Adjust the VOLUME to your desired level.

Setting Up INPUT 1 with a Source

1. Turn the INPUT 1 VOLUME fully counter-clockwise.
2. Set the SIGNAL INPUT switch to LINE LEVEL.
3. Plug the source cable into the INPUT 1 connector.
4. Adjust the VOLUME to your desired level.

Setting Up INPUT 2 with a Source

1. Turn the INPUT 2 VOLUME fully counter-clockwise.
2. Plug the source cable into an INPUT 2 connector.
3. Adjust the VOLUME to your desired level.
12 - English
F1 Model 812
F1 Subwoofer
EQ Switch
LINE OUTPUT EQ Switch
FULL RANGE
Not applicable
WITH SUB
THRU
FULL RANGE
No affect
or WITH SUB*
0 dB (detent)
0 dB (detent)