Connecting your TV to the system
Figure 13
Composite video
connection
The connection panel on
your TV may look different.
It may have fewer Video IN
connections
This audio connection allows
your TV to send sound to your
®
LIFESTYLE
system
Media Center
The instructions below show basic connections to the media center and TV. This simple set of
connections will allow you to use your system quickly. Later in this guide you will find other
options for connecting additional components to your system.
Making the audio connection
Using the supplied stereo audio cable, connect the left (L) and right (R) audio outputs on the
rear panel of your TV to the Audio IN TV L and R on the media center rear panel (Figure 12).
• If the TV has both fixed (FIX) and variable (VAR) outputs, use the ones for fixed output. If the
setup menu for your TV allows, select Fixed in that menu.
• If you have a digital TV, you may connect a digital audio cable as well. This may either be a
single coaxial cable with RCA connectors on each end, or an optical cable, which has a
unique snap fit connector on each end.
Note: It is important to provide the analog connection along with the digital, to prevent a loss
of sound caused by any temporary degradation of the digital signal.
Note: On the TV, be sure to notice which Video IN jack is used. In the example below, the
media center Video OUT is connected to the VIDEO 1 input on the TV. In this case, use your
TV remote control to select VIDEO 1 to view DVDs and see LIFESTYLE
TV
System Installation
®
system menus.
Cable TV, Satellite,
or Antenna cable
Component video con-
nections are explained
later in this guide
This video connection
allows you to view DVDs
and see system menus
17
페이지 인쇄