Bose Lifestyle 48 문제 해결 매뉴얼 - 페이지 6

{카테고리_이름} Bose Lifestyle 48에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Lifestyle 48 32 페이지. Personal music center ii - owner's guide
Bose Lifestyle 48에 대해서도 마찬가지입니다: 설치 매뉴얼 (42 페이지), 매뉴얼 (29 페이지), 설치 매뉴얼 (36 페이지), 소유자 매뉴얼 (25 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (13 페이지), 빠른 설정 매뉴얼 (3 페이지), 소유자 매뉴얼 (30 페이지)

PS18/28/35 Troubleshooting Guide

Theory of Operation

The IC has two enable pins, one of which (pin-8) disables the operation while the other (pin-9)

enables the operation. A voltage pulse higher than 0.6V at pin-8 shuts down the IC and a voltage

pulse higher than 1.2V at pin-9 wakes up the IC. An opamp, an under voltage lockout circuit, and a

soft start circuit are also built into the IC.

Figure 3 is a circuit diagram that shows how the IC is used in the tracking power supply. With a

12V voltage established at pin-12 (Vs), the VCO starts to oscillate, sweeping oscillation frequency

from its start frequency (350 kHz) downward. A gate-driving signal for a low-side MOSFET is

generated at pin-11 with respect to pin-10, and another gate driving signal for a high-side

MOSFET is obtained at pin-15 with respect to pin-14.

Figure 3. Resonant controller IC used in tracking power supply

Figure 4 shows the oscillograms of the two gate driving signals, when the IC alone is powered on

by a 12V DC supply. A dead time of about 280ns, during which both signals are at low level, exists

between the two gate signals. Such a dead time avoids shoot-through of the two power MOSFETs.

It also allows zero-voltage switching as will be explained later.

The frequency of the two signals is controlled by a voltage at pin-7, which is connected to the

output of an opto-coupler. The frequency is about 200 kHz with 0V at pin-7 and 100 kHz with 2V at

pin-7.

Figure 4. Scope photo of two gate driving signals