Bose LT 4402 WR 서비스 매뉴얼 - 페이지 19

{카테고리_이름} Bose LT 4402 WR에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose LT 4402 WR 27 페이지. Weather resistant
Bose LT 4402 WR에 대해서도 마찬가지입니다: 소유자 매뉴얼 (32 페이지)

페이지 인쇄

DISASSEMBLY PROCEDURES

3. Input Panel Assembly Removal

3.1 Remove the twelve screws (11) that

secure the input panel assembly (12) to the

cabinet. Lift the assembly away from the

cabinet. Disconnect the cables that plug into

the PCB. Lift out the assembly.

4. Compression Driver Removal

4.1 Remove the twelve screws (11) that

secure the input panel (12) to the cabinet. Lift

off the rear panel. The gasket should remain

adhered to the cabinet.

4.2 Make a note of the wiring configuration,

and disconnect the wires from the compres-

sion driver. Remove the four screws (14) that

secure the Compression Driver (15) to the

cabinet. Lift the compression driver out of the

cabinet.

5. V2 Two Assembly Removal

5.1 Remove the four screws (10) that secure

the V2 assembly (8) to the cabinet. These

screws are located at the four corners of the

assembly. Do not remove the other screws

around the casting. Carefully lift the assem-

bly out of the cabinet. Make a note of the

wiring configuration, and disconnect the two

wires from the connector.

Model 9402

WR Loudspeaker

Note: Refer to Figure 9 for the following

procedures.

1. Grille Removal

1.1 Remove the fourteen screws (1) that

secure the grille assembly (3) to the cabinet.

1.2 Lift the grille assembly off of the cabinet.

The gasket should remain adhered to the

cabinet.

2. Logo Removal

2.1 Remove the grille using procedure 1

above.

2.2 On the back of the grille, carefully re-

move the slotted washer that retains the

spring and spacer against the back of the

grille. Note the direction the spacer faces.

Slide the spring and spacer off of the logo

post.

2.3 Lift the logo off of the grille.

3. Input Panel Assembly Removal

3.1 Remove the twelve screws (11) that

secure the input panel assembly to the

cabinet. Lift the assembly away from the

cabinet. Disconnect the cables that plug into

the PCB. Lift out the assembly.

4. Compression Driver Removal

4.1 Remove the twelve screws (11) that

secure the input panel (12) to the cabinet.

Lift off the rear panel. The gasket should

remain adhered to the cabinet.

4.2 Make a note of the wiring configuration,

and disconnect the wires from the compres-

sion driver. Remove the four screws (14)

that secure the Compression Driver (15) to

the cabinet. Lift the compression driver out

of the cabinet.

5. V2 Two Assembly Removal

5.1 Remove the four screws (10) that

secure the V2 assembly (8) to the cabinet.

These screws are located at the four

corners of the assembly. Do not remove the

other screws around the casting. Carefully

lift the assembly out of the cabinet. Make a

note of the wiring configuration, and discon-

nect the two wires from the connector.