Bose Panaray LT 9402TM WR 서비스 매뉴얼 - 페이지 22
{카테고리_이름} Bose Panaray LT 9402TM WR에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Panaray LT 9402TM WR 27 페이지. Weather resistant
페이지 인쇄
3. Frequency Power Sweep Test
3.1 Apply an 8 Vrms, 10 Hz signal to the
speaker input terminals.
3.2 Sweep the input frequency from 10 Hz
to 2 kHz.
3.3 Lower the applied input to 4 Vrms, and
sweep the input frequency from 2 kHz to 5
kHz.
3.4 Listen for any buzzes, rattles or other
extraneous noises from the loudspeaker.
Model MB24 and MB12 Series WR Bass
Loudspeakers
Note: For the MB24, ensure that the speaker
under test is in PARALLEL mode for the
following tests. To check the mode the
speaker is set up to operate in, you will need
to remove the eight screws that secure the
input panel assembly in place and verify that
the jumpered connector plugged into the
crossover PCB is in the PARALLEL jack.
Refer to the disassembly procedures in this
service manual for instructions on how to
remove the input panel. This does not apply
to the MB12, as it has only one woofer.
Loudspeaker Wiring Diagrams
1+
4-
1-
4+
2+
3-
3+ 2-
1+
4-
1-
4+
2+
3-
3+ 2-
TEST PROCEDURES
1+
1-
2+
2-
3+
3-
4+
4-
Model 3202
®
Series WR Wiring Diagram
22
1. Rub and Tick Test
1.1 Apply a 10 Vrms, 10 Hz signal to the
input terminals of the speaker.
1.2 No extraneous noise such as rubbing,
scraping or ticking should be heard.
2. Phase Test
2.1 Disconnect the connectors at the driver
terminals. Momentarily apply 10 Vdc + 1 Vdc
to the terminals, observing polarity when
connecting the DC power supply. Both of the
drivers should move outward when the DC
level is applied.
3. Frequency Power Sweep Test
3.1 Apply a 10 Vrms, 10 Hz signal to the
speaker input terminals.
3.2 Sweep the input frequency from 10 Hz
to 250 Hz.
3.3 Listen for any buzzes, rattles or other
extraneous noises from the loudspeaker.
V2
+
-
4.5'
+
-
Mid 1+
4.5'
Mid 1-
MID-FREQUENCY DRIVERS
V2
+
Mid 2+
-
4.5'
+
-
Mid 2-
4.5'
To In+
EAG011-02
C1
+
3UF/250V
To In-
-
HI-
HIGH-FREQUENCY
DRIVER
V2
+
-
4.5'
+
-
4.5'
V2
+
-
4.5'
+
-
4.5'
C2
6UF/250V
L1
Connector
0.72mH/
5556 2Î11P
1.3mm
OUT
HI+
HI
+
-
T1.4hp