Bose RoomMatch RMS218 설치 및 안전 매뉴얼 - 페이지 8

{카테고리_이름} Bose RoomMatch RMS218에 대한 설치 및 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose RoomMatch RMS218 13 페이지. Subwoofer module loudspeaker

Installation

Attaching Bose RMSFLY Side-Plate Rigging Kit

The RoomMatch™ RMS215 subwoofer is shipped with no array rigging hardware. The optional RoomMatch™ RMSFLY accessory part

(343856-0110) is available to facilitate integration of the RMS215 subwoofer in RoomMatch™ Arrays. The RMSFLY side-plate hardware

is not required for floor or ground-stack installations of RMS215 subwoofers. To attach the RMSFLY side-plate rigging hardware to the

RMS215 subwoofer, follow these steps:

1) Remove RMS215 subwoofer from the shipping carton, remove packing materials, and place the subwoofer on the floor beneath

planned suspension point.

2) Remove the eight flat-head screws using a 5.5mm hex key on the left and right sides of the subwoofer (four per side). Included foam

washers under the inserts should remain affixed to the subwoofer.

3) Insert M10 x 40 mm fasteners through individual side-plates, and supplied flat washers, and then into the subwoofer inserts,

tightening by hand as shown in Figure 2. Note the Left and Right part markings for side-plates. After both side-plates are attached,

the RMS215 subwoofer is ready for integration with other RoomMatch™ modules in full-range arrays.

4) Attach the subwoofer/side-plate assembly to its associated array frame or upper subwoofer and tighten bolts by hand to

facilitate alignment. After all bolts are in place, perform final tightening using torque not to exceed 35 to 40 foot-pounds (47 to 54

Newton-meters).

NOTE: U-Shaped side-plate channel faces upward, the raised mounting bosses face the cabinet, and the oblong alignment slot at the

base of the side-plate points toward the front of the loudspeaker.

Figure 1. Remove flat-head screws

Figure 2. Attach side-plate with supplied bolts

NOTE: When using the RMS215 subwoofer with other Bose RoomMatch™ Array Module loudspeakers, thread the supplied Array

Module handles into each RMSFLY side-plate upper center hole to aid in lifting/moving the subwoofers. Remove the handles after

positioning the subwoofer, before final tightening of bolts and elevating the array.

For additional information regarding the design and installation of RoomMatch™ arrays, please refer to the pro.Bose.com website to

download the document RoomMatch™ Array Design and Installation Guide.

Page 8

Installation and Safety Guidelines

pro.Bose.com

English