Atlas Copco PB 14 D 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} Atlas Copco PB 14 D에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco PB 14 D 11 페이지.
페이지 인쇄
1
Assembling the
Press the liner (1) into the anvil
anvil assembly
housing (2).
2
Grease the anvil (4) and replace the
O–rings (3) by new ones.
3
Insert the anvil into the anvil housing (2) (if
necessary tap it lightly with a hammer).
Ensure proper fit.
4
Fit the recoil ring (5), the recoil absorber
(6), the rubber ring (7), and the catcher
housing.
1
Fitting the anvil
Fit the slightly greased O–rings (6, 8 and
assembly and
9) to the location ring (7).
the nosepiece to
2
Fit the location ring (7) to the hammer
the hammer case
case (10).
3
Fit the anvil assembly (5) over it, align it,
then place the nosepiece (3) on top.
4
Fit the anvil assembly and the nosepiece
to the hammer case (10) and secure them
with the six Allen screws (2).
1
Assembling the
Fit the strap casting (4) to the guide nut (7)
front handle
of the hammer case and push the nose
assembly
cap (2) over of the strap casting.
2
Fit the circlip (1).
3
Expand the front handle (6) slightly and let
it engage over the strap casting (4).
4
Fit the screw (5) and the washer and
secure it tightly with the knob (3).
1
Fitting the tool
Insert the latch bar (1) into the boring of
locking
the nosepiece (2).
mechanism
2
Place the spring cover (3), the spring (4),
and the latch retainer (5) on the latch bar
and press the latch bar into the nosepiece
by hitting the latch bar with a hammer.
Carry out a test run and check for strange noises.
Test run and
electrical
Carry out an electrical test (see chapter Electrical and Mechanical Test Instruction).
examination
Repair instruction No. 171.5/94
PB 14 D, PB 14 C
1
2
1
2
3 4
1
2
1
2
3 4
5 6 7 8
5
6 7 8 9
10
3
4
5
6
7
3
4
5
PAGE
11