Bose Virtually Invisible 791 설치 매뉴얼 - 페이지 9

{카테고리_이름} Bose Virtually Invisible 791에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Virtually Invisible 791 17 페이지. Installation guide
Bose Virtually Invisible 791에 대해서도 마찬가지입니다: 설치 매뉴얼 (35 페이지), 설치 매뉴얼 (23 페이지)

페이지 인쇄

English

TAB 2

Cutting the speaker hole

Be sure to cut carefully to make the hole as regular as

possible. However, when the speaker is in place, the

frame overlaps the cutting edge by

masks minor cutting inaccuracies.

1. Hold the cutting blade in a vertical position and keep

it straight as you cut the hole.

This helps prevent the blade from angling away from

the outlined circle.

2. Insert the tip of your saw into the pilot hole and cut

most of the way around the circular outline.

3. Place one hand under the circle to brace it and

complete cutting the hole.

WARNING: Keep fingers away from the cutting blade.

4. Remove the cutout section.

5. Clear away any torn or rough material from around

the hole.

Such material can interfere with a tight seal between

the speaker and the ceiling.

TAB 3

TAB 4

in. (0.6 cm), which

TAB 5

TAB 6

Getting the wire ready

When your speaker cable is within reach of the hole you

have cut, follow the procedure below:

1. Push any insulation away from inside the speaker

hole.

Be sure that all blown insulation is at least 4 to 6 in.

(10 to 15 cm) from the edges of the hole.

2. Locate and pull out at least 14 in. (36 cm) of your

speaker cable.

Allow enough cable for where you stand to connect

the wires.

TAB 7

TAB 8

NSTALLATION