Bose 101 Series II 소유자 매뉴얼 - 페이지 2
{카테고리_이름} Bose 101 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 101 Series II 2 페이지. Fpo music monitor speaker system
Bose 101 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (2 페이지)
페이지 인쇄
© 1997 Bose Corporation
The Mountain, Framingham, MA 01701-9168
AM190197 Rev.02
The Bose
101
Series II Music Monitor
®
®
Speaker System Owner's Guide
Introduction
Thank you for purchasing the Bose 101 Series II Music Monitor speaker system.
It is designed to deliver true high fidelity sound when connected to almost any
receiver.
Unpacking Your 101 Series II Speakers
Both 101 speakers are packed in one carton. Unpack the carton carefully. Save it
and the packing materials for possible future use.
Connecting Your 101 Series II Speakers
Speaker cord consists of two insulated wires. The insulation around one wire is
marked (striped, collared, or ribbed). This marked wire is always positive (+). The
plain wire is always negative (–). These wires correspond to the red (+) and black
(–) terminals on the speakers and the receiver. See Figure 1.
1. Strip approximately
⁄
" of insulation from each end of both speaker wires.
1
2
2. Press the terminal tab on the back of each speaker to insert the appropriate wire.
See Figure 2. Connect one speaker cord to your right speaker. Attach the marked
wire at one end to the red (+) terminal. Attach the plain wire at that end to the black
(–) terminal.
3. Connect the other end of the same cord to the RIGHT SPEAKER OUTPUT of
your receiver. Attach the marked wire to the red (+) terminal. Attach the plain wire to
the black (–) terminal.
4. Connect the second cord to the left speaker and LEFT SPEAKER OUTPUT.
Follow the steps in 2 and 3 above.
®
FPO