Bose 161 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Bose 161에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 161 19 페이지. Bose 161 speakers owner's guide
Bose 161에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), (영어) 사용 설명서 (8 페이지), (독일어) 사용 설명서 (8 페이지), (네덜란드어) 사용 설명서 (8 페이지)
페이지 인쇄
Cleaning your speakers
Use a damp cloth to clean your 161
household cleaners. Do not apply liquids directly to the speakers. If you vacuum the
front grille of the speakers, do so carefully.
Troubleshooting
If you experience problems with your 161 speakers, the following suggestions may
help. If you need additional help, contact your authorized Bose
Bose directly.
Problem
Neither speaker
plays
Bass or treble is
weak
Only one speaker
plays
One speaker still
does not play
Technical information
Quality standard: Syncom
Driver complement: Two (2) 2.5" (6.3 cm) wide-range drivers per speaker
Enclosure: Tuned port, molded ABS resin
Dimensions: 4.17"H x 10.93"W x 4.98"D (10.6 cm x 27.8 cm x 12.6 cm)
Compatibility: Rated 50W IEC; compatible with amplifiers or receivers rated 10-100
watts per channel, rated 4-8 ohms
Wire recommendations: Based on a maximum frequency response deviation of
±0.5 dB.
Gauge
2
18 (0.75 mm
)
2
16 (1.5 mm
)
14 (2.0 mm
2
)
Weight: 8 lbs. (3.6 kg) per pair, in the carton
™
What to do
Check the settings on your receiver or amplifier. Refer to the owners
guide that came with it for instruction on settings.
Check the tonal balance setting on your receiver or amplifier.
•
Check the balance control on your receiver or amplifier.
•
Check the wires connected to the speaker that does not play. Make
sure the wires are in good condition and are firmly connected. See
page 5.
•
Disconnect the wires from both the speaker and the receiver or
amplifier. Disconnect the other cord from its speaker, and connect
that end of the cord to the speaker that doesn't play.
•
If the speaker still doesn't play, the problem is in the speaker. If the
speaker now plays, continue checking for the source of the problem.
•
Disconnect the same cord from the amplifier or receiver. Connect it
to the other outputs on the amplifier or receiver.
•
If the speaker plays, the problem is in the original cord that was con-
nected to that speaker. If the speaker does not play, the problem is in
that channel of the receiver.
®
computer quality control
Length
30 ft (9 m) maximum
45 ft (14 m) maximum
70 ft (21 m) maximum
speakers. Do not use harsh chemicals or
Reference
®
dealer, or contact
7