Bose 201 Series 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Bose 201 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 201 Series 16 페이지. Direct/reflecting speakers
Bose 201 Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (4 페이지), 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (4 페이지), 소유자 매뉴얼 (12 페이지)

페이지 인쇄
Bose 201 Series 소유자 매뉴얼

Choose the cord

Prepare the cord

It is important to use the proper gauge (thickness) of speaker cord.
Wire recommendations
Based on a maximum frequency response deviation of ± 0.5 dB
Gauge
Length
18 (0.82 mm
2
)
20 ft (6 m)
2
16 (1.3 mm
)
30 ft (9 m)
14 (2.1 mm
2
)
50 ft (15 m)
Note: Before running the speaker cord through a wall or under a floor, check your local build-
ing code requirements and safety regulations. If necessary, contact an electrical installer for
this information.
Speaker cord consists of two insulated wires. The insulation around one wire is marked
(striped, collared, or ribbed).
At the ends of each cord, strip approximately
Twist the bare end of each wire so loose strands will not touch across terminals. Be sure to
connect each wire to the proper terminal (positive to positive and negative to negative).
Note: It is sometimes difficult to distinguish wire markings. Inspect both wires carefully.
⁄
1
inch (12 mm) of insulation from both wires.
2
Setting Up
5