Atlas Copco CS 14 안전 및 작동 지침 매뉴얼 - 페이지 7
{카테고리_이름} Atlas Copco CS 14에 대한 안전 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco CS 14 14 페이지. Crawler for christensen core drilling rig
페이지 인쇄
and harmful dust. In order to reduce the injurious
effect.
Wear a breathing mask, use a dust collector, or
spray water with a waterlfoam pump, use hearing
protection in accordance with occupational health
and safety regulations
WARNING Rotating parts
Rotating drillpipes, tools and particularly soil augers
are extremely dangerous to handle. Augers turn with
high torque and can cause severe injury if personel is
caught by extruding parts.
Never touch a rotating auger or any part of an auger
string.
Never reach behind, or around an auger.
Don't try to remove cuttings from a rotating auger.
Augers may be cleaned only when brought to full
stop.
WARNING Emergency situation
An emergency situation can occur due to material
failure or incorrect handling.
Stop the operation by pushing the emergency stop
button or if available pull the trip wire.
Check proper function of the safety equipment at
least once beginning of each shift.
WARNING Gas line pressurized, Explosion
hazard
If the equipment comes in contact with gas lines and
explosives, an explosion could occur. Explosions will
lead to severe injuries or death.
Never operate the machine in any explosive
environment.
Never use the machine near flammable materials,
fumes or dust.
Make sure that there are no undetected sources of
gas or explosives.
When working in areas where gas lines are buried,
make sure that your equipment is placed on the
windward side.
Shut down all combustion engines, like hydraulic
power pack, generators etc.
Leave the machine immediately.
Warn people to evacuate the area.
Contact emergency personnel.
Contact the gas company to shut the gas off.
Stay out of the area until the gas company declares
the area to be safe.
WARNING Electric Shock
When overhead electrical power lines exist at, or
near a drilling site, consider all wires to be alive and
dangerous. If the rig comes in contact with electric
© 2010 Atlas Copco Craelius AB | 2010-06-18
02 Safety Instructions CS14C Ed.0
Safety and operating instructions
circuits or other electrical power sources, there is a
risk of severe injury or death.
Always look up to check for overhead electrical
power lines when raising the mast.
Never work in the proximity of electric circuits or
other electrical power sources.
Make sure there are no hidden electric circuits in
your working area.
Do not step off grid mat if such are used. If you
stand on ground, stay put and do not touch any
equipment.
Alert people in the area; order them to stay out of
the immediate area and not to touch any of your
equipment, including the support container.
Ask the supervisor to contact utility company in
order to switch off the system.
If the strike occurred during drilling, retract
down-hole tool. Do not attempt to break any rod
connection.
Do not add or remove any drill pipes.
Maintenance, precautions
WARNING Hydraulic oil
Spilled hydraulic oil can cause burns, accidents by
slippery conditions and will also harm the environment.
Take care of all spilled oil and handle it according to
your safety and environment regulations.
Never dismount the hydraulic components when the
hydraulic oil is hot.
WARNING Hydraulic system under high
pressure
Maintenance and repair on the machine and the
hydraulic equipment under pressure can lead to
severe injuries. Connections can loosen suddenly,
parts can suddenly move and hydraulic oil can be
ejected.
A
5
0
0
0
0
0
1
7
7