Bose Acoustimass 15 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Bose Acoustimass 15에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 15 18 페이지. Bose owner's manual home entertainment speaker systems acoustimass 15 series ii, acoustimass 16
Bose Acoustimass 15에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Setting Up

Connecting the Acoustimass

The 20-foot (6.1m) system input cable connects the module to your surround receiver (see

Figure 6). The system input cable has a multi-pin connector on one end and several wire pairs

on the other. The wire pairs of the cable may be separated or "unzipped" as much as needed

to comfortably reach the surround receiver connections. Each wire pair is marked on the

cable jacket with RIGHT , LEFT, CENTER, RIGHT SURROUND, LEFT SURROUND, or

CENTER SURROUND to indicate where each wire connects to the receiver.

CAUTION: Before making any connections turn off your receiver and unplug it from the AC

(mains) outlet. Not doing so may result in damage to your system.

CAUTION: Do not connect the powered Acoustimass module directly to your TV unless it

provides surround decoding circuitry and ampliﬁed outputs for all channels.

1. Insert the multi-pin connector on the system input cable into the input jack on the Acous-

timass module. Tighten the two thumbscrews to assure a secure connection.

2. Connect each wire pair on the other end of the system input cable to your surround

receiver. Carefully match the polarity of the connections (+ to + and – to –).

• Attach each marked wire (+) to the appropriate + terminal.

• Attach each plain wire (–) to the appropriate – terminal.

Note: The RCA plug of the system input cable comes with a cover installed. Remove

this cover for connection to the LFE/SUBWOOFER OUT jack. If your receiver has no

LFE/SUBWOOFER OUT jack, leave the plug cover in place.

3. If applicable, connect the RCA plug marked LFE on the system input cable to the

LFE/SUBWOOFER OUT jack on your surround receiver.

CAUTION: Do not allow exposed wires to brush against each other; this could damage your

receiver.

AM264924_00 _V.pdf • August 13, 2002

module to the receiver