Bose Acoustimass 5 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Bose Acoustimass 5에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 5 22 페이지. Powered speaker system
Bose Acoustimass 5에 대해서도 마찬가지입니다: 소유자 매뉴얼 (9 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (22 페이지)

페이지 인쇄

Connect the speakers and the Acoustimass

Figure 5

Speaker cable connections to

the Jewel Cube speaker array

Figure 6

Speaker cable connections to

the cube speaker array

AM262838_00_V.pdf

Connecting the Acoustimass 20 Jewel Cube

Acoustimass module

1. Insert the connector of each speaker cable fully into the jack on the rear of each speaker

(Figure 5). Match the ridge of the connector to the notch at the top of the jack.

2. Connect each 20-foot (6.1 m) cable to the corresponding left or right green jack on the

Acoustimass module. Speaker cables have green connectors at one end, with L (left) and

R (right) molded into the connectors.

To extend the length of speaker cable, you will need a 30-foot extension cable. To order this

part, please call Bose

customer service (request PN 186445-1 black; PN 186445-2 white).

Or, splice in 18-gauge (.75 mm

extension wire, see your dealer, electronics store, or call Bose customer service.

Connecting the Acoustimass 5 cube speaker arrays to the

Acoustimass module

Each speaker cable contains two wires. The wire marked with a red collar is positive (+) and

the ribbed one is negative (–). These wires match the positive (red) and negative (black)

terminals on the back of each speaker. To extend the length of speaker cable, you will need a

30-foot extension cable. To purchase this cable see dealer, electronics store, or call Bose

customer service. To order this part from Bose, please call Bose customer service (request

PN 186445-1 black; PN 186445-2 white). Or, splice in 18-gauge (.75 mm

(connecting + to + and – to –).

1. Match the correct cable to the corresponding speaker location.

• Speaker cables have blue connectors at one end, with L and R molded into the

connectors.

• The red collars on the + wire are labeled LEFT and RIGHT.

2. Connect the wire end of one speaker cable to the terminals on the rear of the matching

cube speaker array.

a. Press the terminal tab on the back of the cube array to insert the marked wire into the

red terminal and the plain wire into the black terminal. Release the tab to secure the

wire.

b. Repeat this step for each of the cube speaker arrays (see Figure 6).

3. Connect each cable to the corresponding left or right blue jack on the Acoustimass

module.

CAUTION: Make sure no strands of wire from any terminal touch any other terminal. Bridged

wires create short circuits that affect proper operation of your system.

December 20, 2001

module

) or thicker cord (connecting + to + and – to –). To purchase

Setting Up

speakers to the

) or thicker cord