Bose Acoustimass 6 Series II 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Bose Acoustimass 6 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 6 Series II 23 페이지. Bose acoustimass 6 series ii: owners guide
Bose Acoustimass 6 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (33 페이지), 소유자 매뉴얼 (28 페이지)

페이지 인쇄

1. Connecting the Speakers

Setting Up Your Acoustimass

Checking your connections

6 Speaker System

Connecting the Acoustimass

CAUTION: Do not connect the Acoustimass module directly to your television unless the

television provides surround decoding circuitry and amplified outputs for all channels.

Use the 20 foot (6 m) cable with five wire pairs to connect the Acoustimass module to your

surround sound receiver. Refer to Figure 8.

1. Connect all wires to the receiver in phase (+ to + and – to –).

a. Connect each wire marked with a red collar (+) to the appropriate red (+) output.

b. Connect each plain wire (–) to the appropriate black (–) output.

2. Match the label on the red collar of each wire pair to the SPEAKER OUTPUT label on the

receiver:

a. LEFT wires go to the LEFT FRONT SPEAKER OUTPUT connections.

b. CENTER wires go to the CENTER SPEAKER OUTPUT connections.

c. RIGHT wires go to the RIGHT FRONT SPEAKER OUTPUT connections.

d. LEFT SURROUND wires go to the LEFT SURROUND (rear) SPEAKER OUTPUT

connections.

e. RIGHT SURROUND wires go to the RIGHT SURROUND (rear) SPEAKER OUTPUT

connections.

3. At the Acoustimass module, check to make sure all connectors are firmly inserted into the

proper INPUTS FROM RECEIVER OR AMPLIFIER jacks. Black connectors go into L and R

jacks. Gray connectors go into C, LS, and RS jacks.

Check all connections from the receiver to the Acoustimass module and the module to the

cube speakers. Check to be sure all speakers are connected to the proper terminals accord-

ing to their position in your room. Refer to Figure 8.

At the receiver, make sure the wires are connected in phase (+ to + and – to –). Incorrect

wiring can result in a total loss of Acoustimass module output.

Be sure to correct any wiring problems before you plug your receiver in and turn it on.

CAUTION: Do not allow exposed wires to brush against each other; this could damage your

receiver.

October 29, 2001

module to your receiver

AM25212_02_V.pdf