Bose Acoustimass 6 Series III 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Bose Acoustimass 6 Series III에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 6 Series III 25 페이지. Home theater speaker sytem
Bose Acoustimass 6 Series III에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지), 빠른 설정 매뉴얼 (1 페이지), 소유자 매뉴얼 (44 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (23 페이지)

페이지 인쇄

English

Español

Figure 6

System input cable

connection

Figure 7

Unzipping the paired wires

Français

Connecting the Acoustimass

The system input cable is 20 feet (6.1 m) long and connects to your surround receiver. Unlike

the speaker cables, this input cable has a multi-pin connector that inserts into the Audio Input

jack on the module (Figure 6).

At the other end of the system input cable, multiple wire pairs "unzip" for easy reach and

insertion into terminals on your receiver. A red collar marks a wire as positive (+) wire.

CAUTION: Do NOT connect your module to the TV, which lacks the required amplification.

The single RCA connector at that end is for use ONLY with a receiver that handles

low-frequency effects and provides an LFE/SUBWOOFER jack (Figure 7).

RCA

connector

for LFE

only

CAUTION: Before making these connections, turn off your receiver to prevent unwanted noises

when you plug the Acoustimass

To make the connections (Figure 8 on page 10):

1. Insert the multi-pin connector on the system input cable into the input jack on the

Acoustimass module. Tighten the two thumbscrews to secure the connection.

2. Connect each wire pair on the other end of the system input cable to your surround

receiver, which should have audio output terminals labeled:

• Right, Left, and Center for the front audio channels.

• Right Surround and Left Surround for the rear channels.

The specific labels on your receiver may differ slightly.

CAUTION: Do not allow exposed wires to brush against each other; this could damage your

receiver.

3. Carefully match the polarity of the connections (+ to + and – to –).

• Attach each red-collared wire (+) to the appropriate + terminal.

• Attach each plain wire (–) to the appropriate – terminal.

4. If applicable to your receiver, insert the RCA plug marked LFE on the system input cable

into the LFE/SUBWOOFER OUT jack on your surround receiver. Remove the cover first.

module to the receiver

Module input jack

System input

cable connector

Wire pair

module into it.

ETTING