Bose FS3B 서비스 매뉴얼 - 페이지 4
{카테고리_이름} Bose FS3B에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose FS3B 16 페이지. Speaker system
Bose FS3B에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지)
페이지 인쇄DISASSEMBLY PROCEDURES
FreeSpace
®
3B Acoustimass
Procedures
Note: Refer to figure 5 for the following
procedures:
1. Grille and Logo Removal
1.1 Use force to pull out the logo (18), then
gently pull the grille (17) away from the baffle
(1). Be careful not to mark the surface of the
grille or the enclosure.
2. Woofer Assembly Removal
2.1 Use a cross-head screwdriver to remove
the 10 screws (10) that secure the rear
cover (3) to the enclosure (2). Gently turn
over the rear cover (3) to allow access to the
woofer assembly (5).
2.2 Remove 4 screws (9) of the woofer
assembly and 3 screws of the transformer
access cover (6). Lift out the transformer
access cover with the transformer (7)
attached to allow access to the crossover
PCB (19).
2.3 Make a note of the wiring configuration
and unplug the four wires of the woofer
assembly from the crossover PCB.
2.4 Lift the woofer assembly out of the
enclosure.
3. Transformer Kit Removal
3.1 Perform step 2.1.
3.2 Remove the 3 screws of the transformer
access cover (6) and lift out the transformer
kit (6, 7, 8) from the mounting hole.
3.3 Make a note of the wiring configuration
and unplug all the wires from the trans-
former.
Re-assembly Note: Make sure the gap for
the transformer wires through the enclosure
is airtight.
®
Bass Module
FreeSpace
1. Grille Assembly Removal
2. Twiddler
4
®
3F Satellite Procedures
Note: Refer to figure 6 for the following
procedures.
1.1 Gently pull the grille assembly (4) away
from the enclosure (8). Be careful not to
mark the surface of the grille or the enclo-
sure.
TM
Assembly Removal
2.1 Perform procedure 1.
2.2 Using a cross-head screwdriver, remove
the four screws (1) that secure the baffle
plate (9) to the enclosure (8).
2.3 Unplug the two wires from the driver (2).
Re-assembly Note: Be sure to observe
polarity when reconnecting the wires. Red
for "+" and black for "-".