Bose WAVE RADIO III 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Bose WAVE RADIO III에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose WAVE RADIO III 28 페이지. Owner's guide
Bose WAVE RADIO III에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (26 페이지), 소유자 매뉴얼 (28 페이지), 서비스 매뉴얼 (10 페이지)

페이지 인쇄

ETTING

OUR

Unpacking

Please check the shipping carton for the following items:

music system III

Wave

AC power cord(s)*

*The appropriate power cord(s) for your region is supplied.

Selecting a location

music system III on a table or other

• Place your Wave

flat surface.

• To enjoy maximum audio performance, place your

music system III across the room from where

Wave

you will be listening.

• For best audio performance, place your Wave

system III within two feet of a wall, and avoid placing

directly in a corner.

Notes:

• Do not place your Wave

surface. It could interfere with AM reception.

• Do not place your Wave

sensitive surface. Like all electrical equipment, it gener-

ates some heat.

• Do not use your Wave

location or any other place where moisture can get

inside.

Connecting to power

1. Insert the small end of the power cord into the con-

nector labeled AC POWER on the rear panel of your

music system III.

Wave

2. Plug the power cord into an electrical outlet.

AC POWER

6 – English

AVE

USIC

Remote control

(battery installed)

Demonstration CD

music system III on a metal

music system III on a heat-

music system III in a damp

III

YSTEM

3. Unwind and straighten the power cord to ensure the

best FM radio reception. The power cord is used as

an antenna.

Setting the clock

After plugging in your Wave

clock using the remote. Your Wave

easily operated using the remote control. Just aim the

remote at the front panel and press the necessary buttons.

1. Press and hold down either Time button for

about 1 sec.

music

Initially, HOLD_TO_SET appears on the display and

then quickly changes to – CLOCK SET – as the

button is depressed.

2. Release the selected Time button.

3. Press Time – to adjust the displayed time backward

or press Time + to adjust the displayed time for-

ward until it matches the current time. You can also

press and hold for rapid adjustment.

4. Wait five seconds for the system to exit the clock

setup mode automatically.

Notes:

• To change the clock display from 12-hour (AM/PM) time

to 24-hour time, see "Changing the time format" on

page 18.

• If the Wave

power outage or uplugging the unit to move it, all system

settings will be permanently retained. However, the clock

time will only be temporarily stored in backup memory for

up to 48 hours.

music system III, set the

music system III is

Note: Press-and-hold operations

require holding the button down for

about one second.

music system III loses power due to a