Bose WAVE RADIO III 서비스 매뉴얼 - 페이지 4

{카테고리_이름} Bose WAVE RADIO III에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose WAVE RADIO III 10 페이지. Owner's guide
Bose WAVE RADIO III에 대해서도 마찬가지입니다: 소유자 매뉴얼 (28 페이지), 소유자 매뉴얼 (28 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (26 페이지), 소유자 매뉴얼 (28 페이지)

페이지 인쇄

DISASSEMBLY/ASSEMBLY PROCEDURES

Note: Refer to Figure 2 for the following

procedures.

1. Terminal Cap Removal

1.1 Using a phillips-head screwdriver,

remove the six screws (4) that secure the

terminal cap (7) to the bass module cabi-

net.

1.2 Gently pull the terminal cap away from

the cabinet. Be careful not to mark the

plastic of the terminal cap or chip the

wood of the bass module cabinet.

2. Terminal Cap Replacement

2.1 Place the terminal cap (7) onto the bass

module cabinet. Make sure it is fully seated

against the cabinet.

Note: Be sure the text on the label is

aligned with the text on the front of the

bass module.

2.2 Replace the six phillips-head screws (4)

removed in procedure 1.1. Do not

overtighten the screws.

3. Crossover Assembly Removal

3.1 Perform procedure 1.

3.2 Using a phillips-head screwdriver,

remove the four screws (9) that secure the

crossover assembly (8) to the terminal

cap (7).

3.3 Slide the crossover assembly off of the

tabs located on the terminal cap.

3.4 Cut the wires as close to the crossover

assembly as possible.

4. Crossover Assembly Replacement

4.1 Strip the wires from the woofer

assemblies (2) and solder them to the

appropriate locations on the crossover

assembly (8).

4.2 Slide the crossover assembly onto the

tabs located on the terminal cap (7).

4.3 Replace the four screws (9) removed

in procedure 3.2.

4.4 Perform procedure 2.

5. Woofer Assembly Removal

5.1 Perform procedure 1.

5.2 Using a phillips-head screwdriver,

remove the four screws (3) that secure the

woofer assembly (2) you wish to remove to

the cabinet.

5.3 Lift the woofer assembly out of the

cabinet and cut the wires as close to the

terminals as possible.

Note: Be sure to replace the woofer

gasket (1) when you replace the woofer

assembly.

6. Woofer Replacement

6.1 Strip the woofer cable wires.

6.2 Using a few small pieces of cellophane

tape, secure the new woofer gasket (1) to

the woofer assembly (2). This will hold it in

place while you install the woofer assembly

into the bass module cabinet.

6.3 Solder the woofer cable wires to the

woofer assembly. Refer to Figure 5.

6.4 Secure the woofer assembly in place

using the four screws (3) removed in

procedure 5.2.

6.5 Perform procedure 2.