3M SH-EXP 설치 매뉴얼 - 페이지 6

{카테고리_이름} 3M SH-EXP에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M SH-EXP 8 페이지. Add on expansion head model for use on twin (2xx), triple (3xx), scale feeder (sf1xx), dual flow (df1xx, df2xx) and dual port (dp1xx, dp2xx, dp3xx)

페이지 인쇄

Inlet Water

Shut Off Valve

Apendix A.

How to install and remove the Inlet/Outlet Fitting using Retention Clips

This product is outfitted with inlet/outlet fittings. The fittings can be attached or removed from the system without tools. Retention clips are

semi-circular in shape with three internal tabs-bottom, center and top. Tabs interlace with windows in the manifold head near each connec-

tion port. Clips are flexible and easily installed following these instructions and illustrations.

1. Insert fitting into manifold.

2. With fitting inserted into manifold port, snap clip into place beginning at the bottom window

3. Push center tab into center window.

4. Finally push top tab into top window.

Installation

Step 1

Removal

Step 1

1. Lift up on top of retaining clip while pulling down simultanously thereby releasing the center tab, pull

bottom of retention clip down to remove.

2. Pull fitting away from expansion head.

Vent Valve

Step 2

Equipment Start-up Procedure

Install cartridges into manifold.

Pressurize system by slowly turning water filtration

system inlet shut off valve to the "ON" position.

Close vent valve.

Check system for leaks.

Flush system in accordance with cartridge performance

data sheet or flush instructions supplied with original

system.

System is now ready for use.

Step 3

Step 2

Step 4