Bose 3-2-1GS Series II 문제 해결 매뉴얼 - 페이지 14
{카테고리_이름} Bose 3-2-1GS Series II에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 3-2-1GS Series II 28 페이지. Home entertainment system
페이지 인쇄
A pair of signal relays, K5000 [sheet 13, C2] and K5001 [B2], permit selection of internally
generated Composite and S-Video signals or pass-through of external Composite and S-Video
signal inputs to the output Composite and S-Video connector J201. When VIDEO_SEL is low,
the console is configured as video pass-through mode which plays external video signals.
When VIDEO_SEL is high, the console is configured as playing video signals from CS98200.
The Component Video (YPrPb) output should be selected whenever the COMP_SENSE signal
is high. Also, when Component Video is selected, the VIDEO_SEL line shall remain low at all
times. This prevents attenuation of the video signal if both sets of outputs (Composite, S-Video
and YPrPb) are connected to other equipment.
6. Tuner Electronics
The tuner function is implemented on a dedicated PCB which has no other essential functions
or hardware. This has the advantage of the console working without needing the tuner board in
circuit. The topology of the tuner circuit itself is very similar to the 321 Series I tuner. There are
three variations of the final assembly. See SD270575 for details.
Note: Refer to the Tuner PCB schematic sheets, 270575, for the following information.
6.1 Main PCB Interface
Interfacing the Tuner PCB to the Main is accomplished through a 13 connection flat-flex cable to
connector J1 [sheet 2, C8]. Below is a table describing the pin functionality...
Pin
Name
Number
1
+12V
2
Supply_Freq_Sel
3
Gnd
4
Tuner_L
5
Tuner_R
6
Gnd
7
Tnrbd_Sel
8
Tnrbd_Clk
9
Tnrbd_Datain
10
Gnd
11
Tnrbd_Dataout
12
Tnrbd_Reset
13
Tnrbd_Flash
THEORY OF OPERATION
Direction
Supply
Sole supply voltage for the tuner board, in normal
operation it draws <100mA. Local 10V(U18) and 5V(U19)
is derived from this
Output
Logic Level output setting the main board switching power
supply frequency determined by a lookup table in the ST
micro (ST72324) for interference avoidance. AM only.
Low, Fsync=97.324kHz
High, Fsync=100.800kHz
Supply
Return for all signals. No differentiation in grounding is
implemented on the tuner board.
Output
Left channel analog audio output.
Output
Right channel analog audio output.
Supply
As 3
Input
Buffered SPI select line for communicating with the
ST72324 from the CS98200 on the main board. Note, this
comm bus is shared with the display so this line allows for
the differentiation of commands between systems.
Input
Buffered SPI clock line for communicating with the
ST72324 from the CS98200 on the main board.
Output
SPI data from the ST72324 to the CS98200. +5V logic
levels.
Supply
As 3
Input
Buffered SPI data output from the CS98200 to the
ST72324.
Input
Hard Resets the ST72324
Input
Control Signal to apply programming voltage to ST72324 in
order to reprogram internal flash.
14
Function/Notes