23zero OSPREY 270 사용자 설명서 - 페이지 3

{카테고리_이름} 23zero OSPREY 270에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 23zero OSPREY 270 10 페이지.

OSPREY 270 USER MANUAL

1. Place the awning on a protected clean surface with rear facing up.

2. At each end of the awning measure and mark the PVC in line with the two channel

grooves at approx 500mm back from end of awning (ideally no more than 600mm) See

Fig. 1 & 2

Fig. 1

3. Using a sharp blade, score a 5mm cross at the centre of the channel groove at your

measurement marking. See Fig.3

Note: The position of the channel grooves can be felt by pressing down and running your

finger along the PVC.

4. Totally un-zip awning cover.

5. Start at one end carefully pull back each side of the PVC so channel grooves are

exposed. See Fig.4

Fig. 4

6. Insert two 25mm M8 bolts in each channel groove and slide across in line with your

marked score in the PVC. See Fig. 5

7. Place scored PVC directly above the bolt and push down firmly until the bolt pierces

PVC and is exposed. See Fig. 6

8. Align bracket holes with bolts and fasten using M8 nut and washer. See Fig. 7

9. Repeat for all three bracket

Attaching brackets to awning

Fig. 2

Fig. 5

Fig. 6

Fig. 3

Fig. 7