3M G5 기술 게시판 - 페이지 4

{카테고리_이름} 3M G5에 대한 기술 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M G5 12 페이지. Drive-thru systems
3M G5에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 기술 게시판 (6 페이지), 기술 게시판 (2 페이지), 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (3 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

3M Graphics Warranties

3M™ Drive-Thru Systems

Mount the G5 Basestation to the Wall

The G5 Basestation can be mounted in the same place as the current XT-1 Basestation. You may use either the Top

or Bottom two mounting screws of the existing XT-1 Basestation to hold the G5 Basestation on the wall.

Which one you choose depends on where the cut-out in the wall that feeds the cable is located. It also depends on

there being sufficient cable length to terminate the Speaker, Microphone, Induction Loop and Timer wires (ex:

Receiving Greet Event from the basestation or Providing Vehicle Detect to the basestation).

Once this is completed you will need to drill the remaining two holes (if necessary) to secure the G5 basestation to

the wall.

IMPORTANT NOTE

If the current cable lengths terminating on the XT-1 Basestation are not long enough to re-wire the G5

Basestation, you may have to pull new cable. If you are short by a few inches, you may splice in sufficient length

of wire from an another spool of 3M Cable. Make sure that the point where you connect the two wires (or

splice) is properly insulated with Electrical Insulation Tape and/or securely held with wire nuts. This ensures

against any accidental grounding of the wires.

Technical Bulletin #161 Release B