3M G5 기술 게시판 - 페이지 9

{카테고리_이름} 3M G5에 대한 기술 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M G5 12 페이지. Drive-thru systems
3M G5에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 기술 게시판 (6 페이지), 기술 게시판 (2 페이지), 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (3 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

3M™ Drive-Thru Systems

Wire Any External Button to Change Order Taking Modes, SPLIT/CROSS, or DAY/NIGHT

Connect using the following GPIOs to re-wire external buttons:

Change Order Taking Modes --- GPIO2 and GND0

Split/Cross

Day/Night

Wire any Alert Message Triggers

The Greeter functionality is built into the G5 Basestation Model G5B1. The user can play back a Greet message to the

customer at the Order Point and/or play a Reminder message at a scheduled time of day. The user can also program

the system to playback an Alert message whenever an external event occurs, such as Opening the Back Door or

Opening the Refrigerator.

You can configure any of the 16 GPIOs on the G5 Basestation Model as ALERT Message Trigger Inputs. For example,

if you chose to wire the back door sensor to GPIO7 and GND0, any time these two pins are shorted the ALERT

message assigned to this input (such as Back Door Open) will play on each headset configured to play the ALERT

Message.

See Illustration below:

IMPORTANT NOTE

Programming the G5 Basestation to play the Alert Message and configuring which Headsets you want the G5

Basestation to play this message on will be covered later in this document.

Technical Bulletin #161 Release B

--- GPIO1 and GND0

--- GPIO3 and GND0