Bose Acoustimass Bass System 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Bose Acoustimass Bass System에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass Bass System 18 페이지. Wireless bass module
Bose Acoustimass Bass System에 대해서도 마찬가지입니다: 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (13 페이지), 소유자 매뉴얼 (6 페이지), 소유자 매뉴얼 (24 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Connect the speakers

Figure 4

Separating cables

Figure 5

Making cube speaker connec-

tions

AM194452_06_V.pdf

Connect the cube arrays to the Powered Acoustimass

module to your receiver. The supplied cables make this easy. The cables may be separated

or "unzipped" as much as needed to comfortably reach the speakers. See Figure 4.

CAUTION: Before making any connections turn off your receiver and unplug it from the

outlet (AC power mains). Not doing so may result in damage to your system.

CAUTION: Never connect the cubes directly to a receiver output. Always connect the cube

arrays to the Powered Acoustimass module, then connect the module to the receiver.

CAUTION: Never use broken or frayed wiring, which can result in electrical shock or

damage to your system. The supplied cables are not intended for in-wall installation. Check

local building codes or enlist a qualified installer.

Connect the Powered Acoustimass module to the center and

front cube arrays

Three individual 20 (6m) foot wire pairs connect the Powered Acoustimass module to the

Center, Right, and Left front cube arrays. Each cable connects to the module with a single

plug.

1. Connect the wire pair marked C to the center speaker. Just press the terminal tab on the

back of the cube array to insert the marked wire into the red terminal and the plain wire

into the black terminal. See Figure 5. Release the tab to secure the wires.

2. Connect the wire pair marked R to the right front speaker (to the right of the TV as you

face it).

3. Connect the wire pair marked L to the left front speaker.

Marked wire

to Red terminal

October 22, 2001

Setting Up

module, and then connect the