Bose Acoustimass16 Series II 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Bose Acoustimass16 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass16 Series II 24 페이지. Home entertainment speaker system
Bose Acoustimass16 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (15 페이지)

페이지 인쇄

English

Español

Figure 6

System input cable

connectors

Figure 7

Unzipping the paired wires

Français

Connecting the Acoustimass

The system input cable is 20 feet (6.1 meter) long and connects the Acoustimass module to

your surround sound receiver. Unlike the speaker cables, this input cable has a multi-pin

connector that inserts into the Audio Input jack on the module (Figure 6).

Module input jack

cable connector

At the other end of the system input cable, multiple wire pairs that "unzip" for easy reach and

insertion into terminals on your receiver (Figure 7). A red collar marks a wire as positive (+).

CAUTION: Do NOT connect your module to the TV, which lacks the required amplification.

The single RCA connector at that end is for use ONLY with a receiver that handles

low-frequency effects and provides an LFE/SUBWOOFER jack (Figure 7).

RCA

connector

for LFE

only

CAUTION: Before making these connections, turn off your receiver to prevent unwanted noises

when you plug the Acoustimass

To make the connections (Figure 8 on page 10):

1. Insert the multi-pin connector on the system input cable into the input jack on the

Acoustimass module. Tighten the two thumbscrews to secure the connection.

2. Connect each wire pair on the other end of the system input cable to your surround

receiver, which should have audio output terminals labeled:

• Right, Left, Center for the front audio channels

• Right Surround, Left Surround, and possibly Center Surround for the rear channels.

The specific labels on your receiver may differ slightly.

CAUTION: Do not allow exposed wires to brush against each other; this could damage your

receiver.

3. Carefully match the polarity of the connections (+ to + and – to –).

• Attach each red-collared wire (+) to the appropriate + terminal.

• Attach each plain wire (–) to the appropriate – terminal.

4. If applicable to your receiver, insert the RCA plug marked LFE on the system input cable

into the LFE/SUBWOOFER OUT jack on your surround receiver. Remove the cover first.

module to the receiver

System input

Wire pair

module into it.

ETTING