3M HEADSET C1060 교체 부품 목록 매뉴얼 - 페이지 12

{카테고리_이름} 3M HEADSET C1060에 대한 교체 부품 목록 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M HEADSET C1060 14 페이지. Wireless intercom system
3M HEADSET C1060에 대해서도 마찬가지입니다: 서비스 정보 (18 페이지), 프로그래밍 매뉴얼 (5 페이지)

페이지 인쇄

Model C1060 Headset Intercom System

Service Procedures (continued)

Replacing the Headband Assembly

Tools Required:

1 - Small size Phillips Screwdriver

1 – Soldering iron

Procedure:

1. Make sure power is off and remove the

battery.

2. Remove the Ear Pad and Ear Cup.

3. Remove three screws from the Inner Case.

4. Separate the case halves by pulling the Inner

Case down, then apart at the bottom.

Carefully raise the Inner Case just over the

On-Off Button and slide down slightly to

separate. Support the Inner Case so the

speaker cable is not strained.

5. Disconnect the power connector located at the

top of the Main PWA.

6. Carefully pull the power wires out of the top

groove of the Headband Clip as shown in

illustration.

7. Remove the Headband Clip from the

Headband end by rotating it 90 degrees and

pulling it free of the headband.

8. Pull the Headband Assembly and cable out of

the Outer Case.

9. Refer to Instructions for "Replacing Battery

Holder Parts".

10. Reassemble by inserting power cable and

Headband through the top of Outer Case with

Headband curve arching away from the front

of the Outer Case.

11. Grasp Headband Clip with open wire groove

up and side slot facing Headband. Insert on

Headband and rotate 90 degrees in place.

12. Carefully press the power wires, one on top of

the other, into the open wire groove of the

Headband Clip. Be sure to press the wires

completely down into the wire groove.

Replacement Parts and Service

13. Plug the power cable into the connector

located at the top of the PWA. Route the

power cable between the On-Off Button and

the large capacitor on the PWA. The power

cable MUST route down the center of the

PWA or the Headband will not extend

properly.

14. Plug the speaker cable into the top connector

of the two connectors located near the bottom

of the Main PWA.

15. Assemble the case halves by inserting the tab

at the top of the Inner Case through the slot at

the top of the Outer Case and carefully lower

the Inner Case over the On-Off Button and

snap it shut at the bottom. Care must be taken

not to pinch any wires.

16. Reinstall the battery, power up, and checkout

operation of the headset, including Headband

slide.

17. Replace three case screws, Ear Cup and Ear

Pad on Inner Case.

Headband Clip