Bose Lifestyle 12 Series II 소유자 매뉴얼 - 페이지 32
{카테고리_이름} Bose Lifestyle 12 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Lifestyle 12 Series II 41 페이지. Bose lifestyle 12 series ii: owners guide
Bose Lifestyle 12 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (22 페이지)
페이지 인쇄
Maintaining Your Lifestyle
Troubleshooting
Problem
System does not
function at all
No sound
No sound from
center speaker
Too much sound
from center speaker
No sound from
surround speakers
Surround speakers
are too loud
Remote control
is inconsistent
or does not work
30
®
12 System
What to do
• Make sure the power connector is inserted securely into the music center, the power cord
is inserted securely into the Acoustimass
are plugged fully into operating AC wall outlets.
• Be sure to select a source (CD, AM/FM, etc.).
• Unplug the music center power pack for a minute, then reconnect it. This allows the unit to
reset itself after a power surge or power interruption.
• Increase the volume.
• Check to see if MUTE is lit on the display. If it is, press the MUTE button on the remote
control to unmute the sound.
• Make sure the audio input cable is connected to the music center FIXED outputs, the black
connector is fully seated in the music center SYSTEM CONTROL 1 jack, and the multi-pin
connector is firmly seated in the Acoustimass module jack.
• Check speaker connections.
• Make sure the digital audio input cable is firmly seated in the music center AUX jack and the
other end of the cable is firmly seated in the connector at the digital source.
• Turn the music center off for 10 seconds, then on again, to restore communication
between the music center and the speakers.
• Check the connections for any external components. Make sure to select the correct
source for the desired input.
• Be sure the CD is placed correctly, label-side up, in the music center, and the cover is
closed.
• Disconnect any headphones.
• Connect the FM and AM antennas.
• Make sure that the center cube cable is connected at both ends.
• Select STEREO+CENTER
• In STEREO+CENTER (3-speaker) mode, press SURROUND
speaker volume.
• Press and hold the STEREO+CENTER
restore the factory preset center volume setting.
• Select SURROUND
+
SURROUND
• Press SURROUND
.
• Make sure the video sound source is stereo and surround-encoded, and the component
used (TV, VCR, DVD, or laserdisc player) is stereo.
• In SURROUND (5-speaker) mode, press SURROUND
• Make sure that the left and right front speakers are connected to the front speaker jacks
(blue) and the left and right surround speakers are connected to the surround speaker jacks
(orange).
• Press and hold the SURROUND
restore the factory preset surround volume setting.
• Check batteries and their polarity (+ and –). See page 17.
• Operate the remote control closer to the music center.
• Move the remote (or the music center) a few feet to avoid an area of "dead spots." See
note on page 19.
• Make sure the audio input cable is firmly seated, uncoiled, and extended as much as
possible.
• Make sure the remote control and music center house codes match. Follow steps 4-7 on
page 28 to match the house code settings.
October 29, 2001
®
module, and the power pack and power cord
(3-speaker) or SURROUND
STEREO+CENTER
(3-speaker) button for 10 seconds to
STEREO+CENTER
(5-speaker) mode.
(5-speaker) button for 10 seconds to
SURROUND
(5-speaker) mode.
SURROUND
–
to decrease center
–
.
AM196573_05_V.pdf