Bose Lifestyle 28 Series II 설치 매뉴얼 - 페이지 10

{카테고리_이름} Bose Lifestyle 28 Series II에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Lifestyle 28 Series II 42 페이지. Dvd home entertainment system
Bose Lifestyle 28 Series II에 대해서도 마찬가지입니다: 운영 매뉴얼 (44 페이지), 설치 매뉴얼 (36 페이지), 소유자 매뉴얼 (25 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (13 페이지), 빠른 설정 매뉴얼 (3 페이지), 운영 매뉴얼 (44 페이지)

페이지 인쇄

YSTEM

LACEMENT

Location choices for the Acoustimass module

Figure 5

Proper and improper

positioning of an

Acoustimass module

Positions for the two surround speakers

The placement goal for rear surround speakers is to create an area of sound around the listener.

By locating them in the back half of your room and directing the cubes away from the listeners,

you prevent them from pinpointing the exact location of the sound source, which is ideal.

The surround speaker cables allow for up to 50 feet (15.2 meters) from the Acoustimass

1. Place the speakers at ear height (when seated) or higher, if possible.The longer the path

from speakers to ears, the better.

2. Adjust one cube of each speaker to reflect sound off one or more surfaces.

Refer to Figure 4 on page 9 and follow these guidelines for selecting a floor location for place-

ment of the Acoustimass module:

• Along the same wall as the TV, or the same end of the room as the front speakers.

• At least 18 inches (45 centimeters) from the TV to avoid magnetically interfering with the TV

image. Move it farther away if you still notice interference.

• Positioned with its grille (with a Bose

closest wall. This prevents the wall from blocking sound output or boosting the bass.

• Where it is not centered between two walls or between a floor and ceiling.

• Within reach of the audio input cable (30 feet or 9.1 meters); the five speaker cables

(20 feet or 6.1 meters for front and center speakers; 50 feet or 15.2 meters for surround

speakers), and your AC power (mains) outlet.

• On its two sides, its top, or its bottom, but NOT standing on either end (Figure 5).

CAUTION: Do not block the ventilation slots for the built-in electronic circuitry in the module.

Top surface

Side surface

BEST

ALTERNATE

For best ventilation,

Place the module

stand the module on

on one of its two

its bottom surface,

broad sides.

as shown, left.

• Under a table or behind a cabinet, for convenience. However, not where furniture or drapes

block any openings on the module.

• With four self-adhesive rubber feet attached to the surface that touches the floor, for added

stability and protection from scratches.

• Where it will not expose electronic media, like tapes, to its magnetic field for long periods.

Français

logo) facing into the room or perpendicular to the

Front end

DO NOT

stand the module

on its slightly curved

back end, which can

cause it to tip over.

Español

English

module.

Ventilation

Back end

openings

DO NOT

stand the module on

its front grille end. The

weight of the module

can damage the grille.