ABSCO SHEDS ADGAZEBO63 매뉴얼 - 페이지 6

{카테고리_이름} ABSCO SHEDS ADGAZEBO63에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABSCO SHEDS ADGAZEBO63 14 페이지. Signature gazebo

FITTING THE SHURELOCK BEAMS

0. Remove the protective plastic coating from

the outside of the beam.

2. Make sure the ends of the beam are all the

way into the brackets and fasten each end with

four FAST100 tek screws.

These are visible screws so take time to position

them on the centreline of the BK3 bracket and

inset equally from the top and bottom.

3. Repeat these steps for the other long beam

SB2 before proceeding to step 4.

On the exterior side of the rear beam that will

get the gutter, only put in the lower teks for now.

Absco Industries

Assembly Instruction Manual

ABSCO SIGNATURE GAZEBO

MODEL: ADGAZEBO63

6.12m W x 3.11m D x 2.60m H

1. Safely lift and place a longer SB2 beam inside

the taller post brackets BK3 as shown.

Overlap to

NOTE: Beam orientation is important to prevent

water entry.

Orientate the beam so the exterior face has the

overlap to the top.

4. Safely lift and place the first shorter beam SB1

inside the post brackets BK3 as shown.

5. Make sure the ends of the beam are as far

as they can go into the brackets, there will be a

small gap at the high-side due to angle.

Fasten each end with four FAST100 tek screws

as before.

6. Repeat these steps for the other SB1 beam

Model: ADGAZEBO63

top

Shorter posts

4/12/23

Overlap to

bottom

1.00