Bose Lifestyle 38 Series III 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Bose Lifestyle 38 Series III에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Lifestyle 38 Series III 13 페이지. Personal music center ii - owner's guide
Bose Lifestyle 38 Series III에 대해서도 마찬가지입니다: 매뉴얼 (29 페이지), 소유자 매뉴얼 (25 페이지), 소유자 매뉴얼 (24 페이지), 빠른 설정 매뉴얼 (3 페이지), 소유자 매뉴얼 (30 페이지)
페이지 인쇄
Svenska
Nederlands
Y
SL2
OUR
WIRELESS SURROUND LINK
To adapt the surround speaker cable for Jewel Cube
Follow these steps before you connect the provided surround speaker cable to your Jewel
Cube
1. Loosen the screws on the Jewel Cube
2. Tighten the screws (Figure 6).
Figure 6
Using the adapter
with a Jewel Cube
speaker
Red terminal
Red band
Using this cable with the adapters attached, follow the steps in "To make the receiver
connections" on page 7. Be sure to match each adapter to the proper speaker, right or left.
What the Status LEDs indicate
On the rear of the SL2 transmitter and receiver, the color of the Status LED indicates how
each unit is functioning. With the power pack plugged in, the LED lights as follows:
•
•
•
•
For information on how to deal with a blinking red LED, see "Troubleshooting" on page 9.
8
Italiano
Français
®
speakers.
ends into its terminals.
• Insert the plain wire (–) into the plain terminal.
• Insert the red-banded wire (+) into the red terminal.
Jewel Cube
speaker
screw
Adapter
on wire
Blinking green: when one unit is trying to link to the other.
Solid orange: in sleep mode for low power use when there is no audio signal to
communicate.
Solid green: the receiver and transmitter are communicating with each other.
This green LED stays lit for several minutes after communications cease.
Blinking red: the SL2 receiver is too hot, or there is a problem with the surround speaker
cable connection between the SL2 receiver and the speakers.
Español
Deutsch
®
speakers
®
speaker adapter so you can insert the two-wire
Dansk
English