Bose Acoustic Wave Music System 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Bose Acoustic Wave Music System에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustic Wave Music System 20 페이지. Music system power pack
Bose Acoustic Wave Music System에 대해서도 마찬가지입니다: 소유자 매뉴얼 (6 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (13 페이지), 소유자 매뉴얼 (5 페이지), 소유자 매뉴얼 (22 페이지)

페이지 인쇄

Selecting a location for your music system and changer

Seating your Acoustic Wave

Figure 2

Seating the Acoustic Wave

music system (a) on top

of the multi-disc changer,

so (b) it sits ﬂat and the two

units communicate

The Acoustic Wave

multi-disc changer is designed to ﬁt right under your Acoustic Wave

music system. Before you connect the two, however, select a good location for the stacked

units.

CAUTION: Setting up the two units separately (on different shelves of an entertainment cen-

ter, for example) is not recommended. Doing so will prevent proper communication between

the two and will adversely affect operation.

When choosing the location, remember that the tonal quality of your Acoustic Wave

system, as with any high-performance sound system, will vary with room placement.

Feel free to try different locations, but keep in mind that...

• The Acoustic Wave

music system is designed to sound best when placed on a shelf,

counter, desk, or table top, 30 to 48 inches (75-120 cm) from the ﬂoor.

• The CD player in the Acoustic Wave

for the CD cover on top of the music system to open.

• The music system should be near the horizontal center of a wall and 6 inches (15 cm) or

less from the surface behind it.

• To increase the bass response, move the unit toward any corner of the room; to decrease

bass response, move it away from the corner.

music system on the multi-disc changer

1. Place the multi-disc changer in the location you have chosen, following the guidelines

above.

2. Carefully seat your Acoustic Wave

sure that it sits ﬂat and the side edges of both units are aligned (Figure 2b).

Note: The music system slips onto raised guides on top of the changer.

(a)

CAUTION: Maintaining a clear optical path between the multi-disc changer and the music

system, shown in Figure 2(b), is important. When the changer is turned on, it sends infrared

(IR) signals that also turn on the music system. If those signals are blocked, there may be no

sound when the changer is playing.

music system needs an allowance of several inches

music system on top of the changer (Figure 2a). Make

(b)

IR signal

receivers

Raised

guides

Setting Up

music

IR signal

emitters

In alignment