Bose SOUNDTOUCH 300 설정 매뉴얼 - 페이지 3

{카테고리_이름} Bose SOUNDTOUCH 300에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose SOUNDTOUCH 300 16 페이지. Universal remote control
Bose SOUNDTOUCH 300에 대해서도 마찬가지입니다: 소유자 매뉴얼 (50 페이지), 빠른 시작 매뉴얼 (40 페이지), 빠른 시작 매뉴얼 (31 페이지), 설정 매뉴얼 (24 페이지), 자주 묻는 질문 (4 페이지), 자주 묻는 질문 (3 페이지)

페이지 인쇄

The universal remote control has four programmable source buttons

(

, AUX,

and

). You can program these buttons to control

your TV, cable/satellite box, DVD or Blu-ray Disc™ player, game system,

DVR or other auxiliary source by entering the code for your source's

brand. There may be several codes for your source. You may need to

perform this procedure multiple times to locate the correct code.

Locate the code

1. Power on your source.

2. Locate the code for your source's brand in the appropriate section

of the Universal Remote Control Device Codes list (located in the

back of the guide).

Enter the code

1. On the remote control, press and hold the appropriate source

button (

, AUX,

then release. For example, to program your TV, press and hold

until all six source buttons glow, then release.

The appropriate source button continues to glow.

2. On the number keypad, enter the code for your source's brand and

press

P R O G R A M M I N G T H E U N I V E R S A L R E M O T E C O N T R O L

) until all six source buttons glow,

Test the code

1. Test the source for basic functions by following the instructions for

your source:

• TV: press the channel buttons. Press MENU. The settings menu

appears. Press and to navigate.

• Cable/satellite box: press GUIDE. The programming guide

appears. Press and to navigate.

• DVD or Blu-ray Disc™ player: press GUIDE. The settings menu

appears. Press and to navigate.

• Game system: press and to navigate through the menu.

2. Based on your source's response to basic functions:

• Remote responds accurately: press EXIT to exit programming

and save your settings.

• Remote does not respond or does not respond accurately:

– If your source button glows: press

code. Repeat steps 1 and 2 in "Test the code." You may need to

repeat this procedure 30 or more times. If all six buttons blink

three times, you have cycled through all codes for your source.

– If your source button is off: your remote exited programming

mode. Repeat steps 1 and 2 in "Enter the code" and steps 1 and

2 in "Test the code."

Note: Your source may not be compatible with universal remote

controls or may not accept IR (infrared) signals. Refer to your

source owner's guide for more information.

to move to the next

E N G L I S H - 3