Bose 2150 설치 관리자 매뉴얼 - 페이지 5

{카테고리_이름} Bose 2150에 대한 설치 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 2150 40 페이지. Commercial power amplifiers
Bose 2150에 대해서도 마찬가지입니다: 설치 관리자 매뉴얼 (39 페이지)

페이지 인쇄

3.1 Using the Bose

commercial power amplifier

Once you have installed and wired the amplifier, follow these tips to get the most from it:

• Verify that all switches (STEREO/MONO, CLIPPING LIMITER, EQ BI-AMP/FULL RANGE

AND LEVEL DEFEAT) are set to the mode you want.

• Turn down the amplifier controls when you power up the system for the first time. Then

advance them slowly, one at a time, to verify that each channel is operating correctly.

• Set input level controls high enough to allow the preceding device to drive the amplifier

to full output. Usually, this is wide open (fully clockwise).

• Write down the settings, either on paper or self-stick dots, and attach to the front of the

amplifier.

• In bi-amplified (multi-amp) systems, start with the low frequency amps turned down or

off. Check each frequency range from highest to lowest to make sure each loudspeaker

component is operating correctly.

3.2 General precautions

Caution: Place the unit where it will be protected from heat and allow adequate

ventilation. Place it away from direct heat sources, such as heating vents and radiators.

Make sure the air can circulate freely behind, beside, and above the unit.

3.3 Mechanical considerations

Either amplifier requires two 3.5" (8.9 mm) rack space units with a 16" (40.6 cm) inside

depth (including the rear supports). When mounting, use four screws with washers to

prevent marring the front panel. Neoprene rubber washers are a good choice because they

grip the screw head and prevent the screws from backing out from vibration or during

transportation.

3.3.1 Rear support

Caution: If either unit is rack mounted and the rack is transported , you must me-

chanically support the rear of the amplifier. You can place a shelf across the rear of the

amplifier or use brackets in such a way as to support the rear of the unit.

AM259107_00_V.pdf

Model 2060 or Model 2150

3.0 Using The Amplifiers

November 19, 2001