Bose Companion 3 Series II 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Bose Companion 3 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Companion 3 Series II 22 페이지. Multimedia speaker system
Bose Companion 3 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (10 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (26 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 자세한 조립 지침 (2 페이지), 설치 매뉴얼 (20 페이지), 사양 (6 페이지), 브로셔 및 사양 (4 페이지), 소유자 매뉴얼 (19 페이지), 서비스 매뉴얼 (36 페이지), 서비스 매뉴얼 (16 페이지)

Bose Companion 3 Series II 소유자 매뉴얼
Setting Up Your Lifestyle
®
Figure 13
RC-5 remote switch
settings

Connecting speakers to your Lifestyle

Figure 14
Speaker cable connections
on the amplifier
14
®
Stereo Amplifier
Setting up the RC-5 remote control
If your system uses a Model 5 music center, you need to set up a second RC-5 remote control to operate
your Lifestyle
®
stereo amplifier.
1. Remove the remote control battery cover and locate the miniature switches (Figure 13).
2. Make sure that the house code settings (switches 1, 2, 3, and 4) match those in your first remote.
3. Slide switch 5 down (off) and 6 up (on).
Note: Refer to your Lifestyle
®
than one room.
CAUTION: DO NOT connect the amplifier to powered speakers of any make or model, nor to any amplified
music sources. Doing so may cause damage to the equipment.
Speaker cable consists of two insulated wires. One wire is usually marked (striped, collared, or ribbed), indi-
cating that it should be connected to the positive (+ or red) terminal. The plain wire should always be con-
nected to the negative (– or black) terminal. For recommended wire sizes and lengths, see "Wire
recommendations" on page 18.
• Connect the right speaker cable to the SPEAKER OUTPUT R terminals (Figure 14). Press the red terminal
tab. Insert the wire coming from the speaker's positive (+) terminal into the red jack and release the tab.
Press the black terminal tab. Insert the wire coming from the speaker's negative (–) terminal into the black
jack and release the tab.
• Connect the left speaker cable to the SPEAKER OUTPUT L terminals in the same way.
Notice which speaker cable is connected to the L (left) output, and which is connected to the R (right) output
on the back of the amplifier. Be sure that the speaker positioned on the left in the listening area (as you face
it) attaches to the cable connected to the L output.
January 4, 2002
system owner's guide for more information on operating your system in more
ON
l
2 3 4
5 6 7 8
stereo amplifier
®
K
40
AM262840_00_V.pdf