Bose FreeSpace E4 Series II 소유자 매뉴얼 - 페이지 19

{카테고리_이름} Bose FreeSpace E4 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose FreeSpace E4 Series II 33 페이지. Business music system
Bose FreeSpace E4 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (4 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (15 페이지)

페이지 인쇄

6.3.4 Source assign

In the Source Assign control, you can choose which system

sources will be available in each zone. The Source Assign control

panel lists all system sources on the left and zone sources on the

right. Sources are assigned by moving them from the System

Sources list to the ZONE Sources list.

Factory default settings

LINE 1 input source is assigned and routed to all four zones.

Programmer's Notes:

• Because the E4 hardware is a router, at least one

source must always be assigned to a zone.

• If you try to remove all sources from a zone, the last

active source will always remain assigned to the zone.

• This function is disabled for zones in which Auto Volume

is enabled (On). If you turn Auto Volume off and change

source assignments, you will need to recalibrate Auto

Volume.

• Any source assigned to ZONE 4 will also be sent to the

AUX OUT/CONTROL output.

To assign a source to a zone

Select a source in the System Sources list.

Click the right arrow ( ) button to move the highlighted

selection to the ZONE Sources list.

6.0 E4 System Setup

When the source appears in the ZONE Sources list, it is

assigned to the current zone. Once a source is assigned to a

zone, that source is no longer available in the System

Sources list and appears grayed out.

To unassign a source

Select the source in the ZONE Sources list.

Click the left arrow () button to move the highlighted selec-

tion to the System Sources list.

To route a source to a zone

Double-click on the source in the ZONE Sources list. When the

source is routed, a sounding-speaker icon appears next to the

source.

49 of 80

Programmer's Note: The FreeSpace

software automatically disables keys of unassigned

sources when a Flash Hardware Configuration

command is performed.

Installer™