Bose FreeSpace E4 Series II 소유자 매뉴얼 - 페이지 23
{카테고리_이름} Bose FreeSpace E4 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose FreeSpace E4 Series II 33 페이지. Business music system
Bose FreeSpace E4 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (4 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (15 페이지)
페이지 인쇄
6.3.8 Dynamic EQ
The Dynamic EQ control panel provides an on/off control to
enable/disable Dynamic Equalization in the current zone.
Dynamic EQ should only be used in either of the following
conditions:
• The system contains extended bass or a FreeSpace
system.
• A user interface is being used to control the volume and no
autotransformers are being used on the speaker line. When
autotransformers are used, the system cannot accurately
monitor the output level of the system, and as a result, cannot
provide the appropriate response for the current listening level.
Factory default settings
Dynamic EQ is set to Off.
Dynamic EQ compensates for a perceived loss of bass response
at low listening levels. Based on the current output level of the
E4 system, additional bass and high frequency will be added.
For Dynamic EQ to operate correctly, make sure the hardware
is connected properly:
• An Auto Volume or Standard wall plate must be connected to
the WALL PLATE CONNECTION input connector.
• The speaker(s) must be directly wired to the ZONE OUT
connector.
E4 System
ZONE OUT 1
WALL PLATE
CONNECTION 1
6.0 E4 System Setup
• DO NOT USE AUTOTRANSFORMERS: DO NOT use an
®
3 speaker
6.3.9 Auto Volume
The Auto Volume function controls the volume level in a zone in
relation to its environmental noise. Using the Auto Volume control
pane, you can configure and calibrate this function for each zone.
Auto Volume
On/Off states
ZONE 1
Speaker
Factory default settings
Standard or
Auto Volume
user interface
53 of 80
auto transformer on the speaker line to adjust the speaker
volume. Dynamic EQ will not operate properly with this
added component.
Adjustment
E4 System
ZONE OUT 1
WALL PLATE
CONNECTION 1
Auto Volume calibration
reset button
Auto Volume
calibration button
Auto Volume
Auto Volume Tracking
Off
Equal to background noise
Volume
ZONE 1
Speaker
Standard or
Auto Volume
user interface
Auto Volume
Tracking settings