Bose FreeSpace IZA 2120-LZ 설치 및 운영 매뉴얼 - 페이지 22

{카테고리_이름} Bose FreeSpace IZA 2120-LZ에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose FreeSpace IZA 2120-LZ 48 페이지. Integrated / zone amplifiers
Bose FreeSpace IZA 2120-LZ에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (48 페이지)

페이지 인쇄

Front and Rear Panels

ZA 2120-LZA/HZA Rear Panel

Figure 7. FreeSpace ZA 2120-HZA amplifier rear panel

Figure 8. FreeSpace ZA 2120-LZA amplifier rear panel

q AmpLink - INPUT RJ-45 connector that receives up to the first 8 digital audio channels from a Bose® AmpLink

product. The amp also supports a THRU path for daisy-chaining those 8 digital audio channels to other Bose

AmpLink products at a maximum distance of 10 m between products.

CAUTION: Shielded EIA/TIA 568B straight CAT 5 cable, or equivalent, is required for proper AmpLink

operation. Unshielded cable is not supported and may cause AmpLink audio to operate improperly. Do NOT

connect either RJ-45 port to an Ethernet-based network.

w AmpLink ERR LED - Solid yellow indicates muted audio from the mute connector. Blinking yellow indicates an error,

which will also mute the audio.

e AmpLink LNK LED - Solid green indicates normal operation.

r INPUT SELECT - Switch selects if analog or AmpLink audio inputs are used. The default state is analog. Only switch

settings when the amplifier is powered off.

t ANALOG INPUT - balanced and unbalanced line-level input connectors.

y AUTO STANDBY - If enabled (ON), the amplifier will go into standby mode after twenty minutes without an input

signal. If in standby mode and an audio signal is detected, the amplifier will automatically wake and amplify audio

within 0.7 seconds. The OFF position disables the feature.

u INPUT - The input can be set to either DUAL mono inputs or SUMMED to one mono input.

i OUTPUT - The output can be set to STEREO or MONO.

o REMOTE 1 Control - Sets the REMOTE 1 input to control both outputs (or zones) simultaneously (ZONE 1+2), or

allows each REMOTE input to control its own output (ZONE 1). If only one remote is being used, then this switch

must be set to ZONE 1+2.

a 70V/100V - Sets the outputs 70V or 100V.

s CONTROLCENTER - RJ-45 input connector for the CC-1 ControlCenter zone controller, or the CV41 if connecting to

two non-ganged CC-1s to the ZA 2120-HZA. If the two CC-1s are ganged together, then the CV41 is not needed.

CAUTION: Do NOT connect this RJ-45 port to an Ethernet-based network.

d MUTE - Contact closure connection that upon trigger (short) will mute all outputs.

f OUTPUT TRIM - Allows for up to 40 dB attenuation of each loudspeaker output.

g OUTPUT - Two inverted 2-pin Euroblock connectors for loudspeaker connections. Outputs are not bridgeable.

22 - Installation Guide

o a

pro.Bose.com