Bose Lifestyle 35 운영 매뉴얼 - 페이지 41

{카테고리_이름} Bose Lifestyle 35에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Lifestyle 35 44 페이지. Dvd home entertainment systems
Bose Lifestyle 35에 대해서도 마찬가지입니다: 설치 매뉴얼 (32 페이지), 운영 매뉴얼 (48 페이지), 소유자 매뉴얼 (22 페이지), 운영 매뉴얼 (46 페이지), 운영 매뉴얼 (34 페이지)

페이지 인쇄

1. The Remote Control

Problem

FM sound is distorted

FM sound is noisy in sur-

round mode

Sound is distorted

No tape, CD, VCR, or TV

sound.

You forgot your password

Media center display says:

NOT CONNECTED

LIFESTYLE

remote does

not control your TV, VCR,

cable/satellite box, or

other external component.

Your TV turns on and off

unexpectedly.

What to do

• Adjust antenna position to reduce interference.

• Weak FM stations will produce static in the surround speakers. Select the 2-speaker

mode to minimize noise.

• Make sure speaker cables are not damaged and the connections are secure.

• Reduce the output level from any external components connected to the media center.

• Check the connections.

• Make sure the component is turned on.

• Refer to the component owner's manual.

• Enter a password of 2673 to access the parental controls and then create a

new password.

• Make sure the audio input cable is ﬁrmly seated in the media center

SPEAKER ZONE 1 jack.

• Make sure correct codes are set. See "Programming your LIFESTYLE® remote to con-

trol your TV" on page 19.

• Make sure that the front of the media center is not obstructed. The IR emitters that send

commands to your external components are behind the front panel display.

• If you still cannot control your external components successfully, you may need to con-

nect the external IR emitter, included with your system, to the IR EMITTER jack on the

rear panel of the media center. See "Connecting the optional IR emitter cable" in your

LIFESTYLE

Installation Guide.

• Reposition the TV on/off detector on the back of your TV.

• Verify that the TV on/off detector is working properly by choosing TV Status in the

Settings (TV) menu. When you turn on your TV, the status line that reads, "Detected TV

Power: Off" should change to "Detected TV Power: On".

AM259776_02_V.pdf • April 23, 2002

Reference