Bose Aviation Headset Series II 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Bose Aviation Headset Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Aviation Headset Series II 28 페이지. Bose owner's guide aviation headset ii

페이지 인쇄

Operational Advisories

As with any complex electronic device, it is possible for this headset to

experience a failure during operation. Such a failure may include loud

tones, distortion and loss of communications signal in the headset when

used in the active or "on" position. The system is "on" when the rocker

switch is "up".

Note: This failure could prevent continued use of the headset in the "on"

position.

These loud tones and the related loss of communications can be elimi-

nated for the duration of the flight simply by switching the headset off. (The

system is off when the rocker switch is "down.") With the switch off, the

headset continues to function in the passive mode, maintaining full

communication capabilities.

We strongly recommend that as a responsible pilot, you ensure you can

hear and recognize typical aircraft sounds while you are using the headset.

Limit the volume of your headset to safe levels so it does not interfere with

your ability to hear informational sounds, such as those emitted by warning

alarms; i.e., stall warning, gear up.

Avoid setting the volume controls at high levels that may affect your

hearing during extended periods of headset use.

The Bose

Aviation Headset Series II has been tested and found to comply

with limits for a class B digital device, pursuant to part 15 of the FCC rules.

These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/television technician for

help.

This apparatus does not exceed the class B limits for radio noise emis-

sions from digital apparatus set out in the Radio Interference Regulations

of the Canadian Department of Communications. It also complies with

Canadian ICES-003 Class B.