Bose Aviation Headset X 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Bose Aviation Headset X에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Aviation Headset X 36 페이지. Owner's guide
Bose Aviation Headset X에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (1 페이지), 소유자 매뉴얼 (36 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (36 페이지)

페이지 인쇄

Getting Your Headset Ready for Use

Notes

For use with a stereo intercom, connect the left and right channels to

their respective positions. For monaural operation, connect pins 3 &

4 together to the tip of the existing phone jack.

Do not use excessive force or bend the installed connector. This may

damage or break internal solder joints.

If the boom microphone works on radio transmit but not through the

intercom, check pin 6. It may be incorrectly wired to the PTT seg-

ment of the microphone jack.

The wires connecting pins 3 & 4 and pins 5 & 6 are shielded, twisted

pairs with a black wire shield termination exiting each pair. If existing

wiring is not shielded, connect shields to existing audio wiring

shields, or connect shield from Comm L and Comm R wire pair to

audio ground.

The Bose

aircraft panel connector cannot be installed to an audio

system using transformer-coupled audio outputs. Call the Bose Avia-

tion Headset Department for details.

Use proper adhesives

Adhesives approved for use with this connector are:

• Ciba-Geigy Uralane 5754-A/B

• Lord 710

• VTCS-6 Vibratite

Do not let cyanoacrylate-based adhesives, ﬂux remover, or other

caustic compounds contact the connector body. These chemicals

cause irreparable damage to the connector. For information on

chemical compatibility and connector part number, call LEMO

USA,

Santa Rosa, CA at 1-800-444-5366.

AM270261_00 V.pdf May 16 2003