Bose Aviation Headset X 소유자 매뉴얼 - 페이지 27

{카테고리_이름} Bose Aviation Headset X에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Aviation Headset X 36 페이지. Owner's guide
Bose Aviation Headset X에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (1 페이지), 소유자 매뉴얼 (36 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (36 페이지)

페이지 인쇄

Replacing parts

Headset Care and Maintenance

Headband cushion

1. Remove the cushion as described below.

2. Place the cushion in a solution of water and a mild detergent

such as Woolite.

3. Allow the cushion to air dry. Then, reattach by following the

instructions below.

Removing environmental moisture

If the protective inner screen becomes damp, due to environmental

moisture such as light rain, dew, perspiration, or condensation, allow

it to air dry only. Do not use electric heaters, blowers, or hairdryer

type devices to dry the inner screen.

If the headset is immersed in liquid, do not use it. Contact the Bose

Aviation Headset Department for assistance.

Through normal use, parts like windscreens and ear cushions may

require periodic replacement.

Microphone windscreen replacement

1. Remove the band that secures the windscreen by rolling the

band from the tip of the microphone.

2. Gently pull the windscreen off of the microphone.

3. Slide-on the replacement windscreen and make sure that it ﬁts

completely over the microphone.

4. Roll a new band to the proper position, about

end of the windscreen, to secure it.

Ear cushion replacement

1. Grasp the ear cushion skirt where it folds into the slot on the ear-

cup (Figure 21 on page 28).

2. Gently pull the ear cushion skirt up and away from the earcup.

3. Properly position the replacement ear cushion against the ear-

cup.

AM270261_00 V.pdf May 16 2003

inch from the