Bose Lifestyle 35 Series II 설치 매뉴얼 - 페이지 13

{카테고리_이름} Bose Lifestyle 35 Series II에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Lifestyle 35 Series II 36 페이지. Noise cancelling
Bose Lifestyle 35 Series II에 대해서도 마찬가지입니다: 설치 매뉴얼 (42 페이지), 소유자 매뉴얼 (25 페이지), 소유자 매뉴얼 (24 페이지), 소유자 매뉴얼 (13 페이지), 빠른 설정 매뉴얼 (3 페이지), 운영 매뉴얼 (46 페이지), 소유자 매뉴얼 (36 페이지), 소유자 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (2 페이지), 공장 초기화 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 소유자 매뉴얼 (38 페이지)

Figure 8

Making the plug-in cable

connection

2. Insert the speaker plug of each cable fully into the jack on the rear of one of the five

speakers. The raised part on the plug slips into a notch at the top of the jack.

3. Connect the RCA connector at the other end of each cable to the corresponding jack on

the Acoustimass

module (Figure 10 on page 14).

• Blue connectors go into the matching left front, center, and right front jacks.

• Orange connectors go into the matching left surround and right surround jacks.

Making the two-wire connections for cube or cube array speakers

Note: The surround speaker cables are joined together for your convenience, providing an

easy-to-use cable for connecting the surround speakers. To run the cables in different direc-

tions from the Acoustimass module, simply pull apart the cables as needed.

Note: To lengthen the speaker cables, use heavy-duty RCA extension cables, or splice in 18-

gauge or thicker cord (connecting + to + and – to –). To purchase extension cables, see your

dealer or electronics store, or call Bose

included with your system.

In Figure 9, the wire marked with a red collar is positive (+) and the plain one is negative (–).

These wires match the positive (red) and negative (black) terminals on the back of each

speaker.

1. Match the correct cable to the corresponding speaker location.

• Front speaker cables have blue connectors at one end, with L (left), R (right), or

C (center) molded into the connectors. A red collar on each + wire is labeled LEFT,

RIGHT, or CENTER.

• Surround speaker cables have orange connectors at one end, with L (left) or R (right)

molded into the connectors. A red collar on each + wire is labeled LEFT or RIGHT.

System Installation

customer service. Refer to the Bose address list